Electrolux ESL 6251 manual Electrical Connection, Changing a fuse

Page 36

Electrical Connection

Any electrical work required to install this appli- ance should be carried out by a qualified electri- cian or competent person.

1 WARNING - This appliance must be earthed.

The manufacturer declines any responsibil- ity should these safety measures not be ob- served.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appli- ance rating plate.

To isolate the dishwasher from the mains, remove the mains plug.

Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason,

Green & Yellow

 

proceed as described below.

 

 

The wires on the mains lead are coloured in accord-

 

ance with the following code.

 

 

Green and Yellow:

Earth

 

Blue:

Neutral

 

Brown:

Live

 

Blue

Brown

• The wire coloured green and yellow must be con-

 

nected to the terminal marked with the letter “E“ or

 

by the earth symbol E or coloured green and yel-

Cord Clamp

low.

The wire coloured blue must be connected to the terminal “N“ or coloured black.

The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1 WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) haz- ard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not re- tained.

36

Image 36
Contents User information Following symbols are used in the text Dear CustomerContents Safety Prior to using for the first timeChild Safety General SafetyDiagram of Appliance Control PanelFunction button Refill with dishwasher saltRefill with rinse aid Prior to Using for the First Time Setting the Water SoftenerSetting manually Setting electronically IIIOnly when using the dishwasher for the first time Adding dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Activating/deactivating the acoustic signal Daily use Loading cutlery and dishesLoading cutlery Pots, Pans, Large PlatesCups, Glasses, Coffee Service Adjusting the Height of the Upper Basket Type Raising / Lowering the upper basketMaximum height of dishes Upper basket Lower basketAdding Detergent Using 3in1 detergents Concentrated detergentsDetergent tablets Selecting the dishwashing cycle Cycle Table Programme Sequence Dishwashing Suitable TypeFor Soiling Consumption Values2Selecting a programme Interrupting or Cancelling a dish- washing cycle Cancelling the wash programmeStarting a dishwashing cy- cle Setting the Delay Timer Switching Off the dish- washerRemoving the Dishes Care and cleaning Cleaning the filtersCleaning the spray arm jets Upper basket spray armBottom spray arm What to do if Remedying small malfunc- tionsMalfunction Possible cause Remedy Short warning tone, continuMalfunction Possible cause Remedy If the Dishwashing Results are not Satisfactory Dishes are still dirtyDishes do not dry and are not shin- ing There are dried water drops on the glass- es and dishesDisposal Packaging materialOld appliance Technical data Dishwashers that can be fully integratedSample loading arrangements Lower basket with cutlery basket Cutlery basketSafety Information for the Installation Installing the Dishwasher Dishwashers that can be fully inte- gratedConnecting the dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Anti-flood systemElectrical Connection Changing a fuseConnecting systems Standard guarantee conditions European GuaranteeThis guarantee does not cover ExclusionsFor Customer Service in the Republic of Ireland please con 0870 5 929Customer Care Electrolux plc