Electrolux ESL 6251 manual Setting electronically, Iii

Setting electronically:

1.Press the ON/OFF button.

3If the LED indicator of only one programme button is illuminated, this wash programme has been activated. The wash programme must be deselected:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds.

The LED indicators of all the programme but- tons that can be selected will illuminate.

2.Press function buttons 2 and 3 simultaneously and hold them down.

The LED indicators for function buttons 1 to 3 will flash.

3.Press function button 1.

The LED indicator for function button 1 will flash. The multi-display will indicate the hardness setting.

4.Pressing function button 1 increases the hard- ness setting by 1.

(Exception: hardness setting 1 follows hardness setting 10).

5.When the hardness setting is correct, press the ON/OFF button.

The hardness setting is now saved.

If the water softener is set electronically to “1”, this switches off the control indicator for dishwasher salt.

	Water hardness		Setting for		Indicator	Number of
			water hardness
					on the multi-	acoustic-
in	in	Range	Manual	Electronic	display	signals1)
°d 2)	mmol/l 3)
51 - 70	9.0 - 12.5			10 4)	10L	10
43 - 50	7.6 - 8.9			9	9L	9
37 - 42	6.5 - 7.5	IV	1	8	8L	8
29 - 36	5.1 - 6.4			7	7L	7
23 - 28	4.0 - 5.0			6	6L	6
19 - 22	3.3 - 3.9	III		5	5L	5
15 - 18	2.6 - 3.2			4*	4L	4
11 - 14	1.9 - 2.5	II	0*	3	3L	3
4 - 10	0.7 - 1.8	I/II		2	2L	2
below 4	below 0.7	I		1	1L	1
				no salt required

1)The water hardness will only be indicated acoustically if the acoustic signal has been activated.

2)(°d) German degree, measure of the hardness of water

3)[mmol/l] millimol per litre, international unit for water hardness

4)On this setting the length of the dishwashing cycle may be slightly longer.

*) factory setting

8