Electrolux 60800 manual Electrical Connection, Changing a fuse

Page 39

Installation and Connection Instructions

Electrical Connection

	Any electrical work required to install this appliance should be car-
	ried out by a qualified electrician or competent person.
1	WARNING - This appliance must be earthed.
	The manufacturer declines any responsibility should these safety

measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are coloured in accordance with the following code.

Green

& Yellow

BlueBrown

Green and Yellow : Earth

Blue	: Neutral
Brown	: Live

Cord Clamp

•The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

•The wire coloured blue must be connected to the terminal “N“ or col- oured black.

•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.

39

Image 39

Contents Ökofavorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions General Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use POM For polyoxymethylene, e.g. plastic clips DisposalDisposing of the Packaging Material Disposal of Old AppliancesEconomical and Ecological Dishwashing Appliance Features and Control Panel Multi-Display can display Control PanelHardness range of the water in your area Prior to using for the first timeAdjust the Water Softener SaltOperating Instructions Turning it anticlockwise Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher salt Open the door, remove the lower RackFill with rinse aid Filling with Rinse AidOugh rinsing, spot and streak free drying Age the applianceDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesForks in the cutlery tray Loading CutleryTioned horizontally in the upper basket Place knives, small spoons and smallWork surface If you use the grid insert, it is notTo ensure that the cutlery basket Both parts of the two part handleLoad large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans Large PlatesLoading Cups, Glasses and Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Lowering the Upper BasketFill with detergent Filling with DetergentDetergent Recommendations Bio Wash Programmes and Concentrated DetergentsSoiling Selecting the Wash Programme Programme TableChanging the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeDishwasher Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startImmediately after the end of the programme Switching Off the DishwasherLoad Sensing Sensor Logic Emptying the DishwasherCleaning the Filter Care and CleaningStances What to do, ifSymptom Possible Cause Solution Error messagesDishes are wet and dull There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyTechnical Data Lower rinse aid dosingThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket Cutlery basket Installing the Dishwasher Free-Standing AppliancesCannot be kinked or crushed Unscrew the screws 1 from the elbows on the back side Connect the inlet hose Connecting the Dishwasher Water Connection Permitted water pressureWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions Page 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG