Electrolux SANTO 4085-8 KG manual Technical Terminology, Refrigerant Circuit, Evaporator

Page 40

Symptom

Solution

 

If the door seal is not airtight (probably

 

after reversing the door) apply warm air

 

to the non sealing area using a hair dryer

Excessive build up of frost.

set to a gentle heat. (do not use a fan

 

heater for this purpose). This will make

 

the rubber more supple and allow it to

 

revert to its original shape.

Noise

Refer to Normal Operating Sounds

The compressor does not start

This is normal, the compressor starts after

immediately after changing the

a period of time.

temperature setting.

 

 

 

If after the above checks there is still a fault, call your local AEG Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for in-guarantee service calls.

Technical Terminology

•Refrigerant

Liquids that can be used to a generate a cooling effect are known as refrigerants. They have a relatively low boiling-point, indeed so low, that the warmth from the food stored in the fridge or freezer can cause the refrigerant to boil and vaporise.

•Refrigerant Circuit

Closed circulation system that contains the refrigerant. The refrigerant circuit comprises primarily of an evaporator, a compressor, a condenser and pipe work.

•Evaporator

The refrigerant is evaporated in the evaporator. Similar to all other liquids, refrigerant requires heat to evaporate. This heat is removed from the interior of the appliance, as a result the interior is cooled.

The evaporator is therefore located inside the appliance or placed in foam immediately behind the inner wall and thus not visible.

40

818 18 12-01/0

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Santo 4085-8 KG Dear customer Contents Service & Spare Parts Important Safety Instructions Prior to InstallationInstallation RefrigerantChild Safety Maintenance and CleaningDuring Use ServicingPackaging Environmental InformationOld Appliances Appliance Transport Before UseRemove the transport fittings from the storage shelves Installation Location InstallationFitting the Door Handles Refrigerator/freezer needs air Appliance AlignmentElectrical Connection Reversing The Door Cover on the plinth from the left to the rightUnscrew the centre door bearing 818 18 12-01/0 Reversing The Door Appliance Description View of ApplianceFreezer tray with Cold Accumulation Block Control Panel Temperature setting buttons Temperature DisplaysPrior to Initial Start-Up Refrigerator Start-Up Initial Start-UpFreezer Compartment Start-Up Temperature Adjustment COOLMATIC/FROSTMATIC Switching the Appliance Off If the appliance is not to be used for an extended periodHoliday Mode Temperature Warning Control and Information SystemsOpen Door-Warning For the fridgeOpening the Freezer Compartment Door Function ErrorsFor the freezer Interior Accessories Storage ShelvesBottle rack Important Only store unopened bottles horizontallyVariable Inner Door Drawers and CompartmentsBottle Holder Vario drawer-setCorrect storage Freezing Preparation of Ice Cubes Frozen StorageTips Refrigerator is defrosted automatically DefrostingFreezer Compartment Defrosting Pull out the water drain spout Energy Saving Advice Hints and TipsNormal Operating Sounds Food StorageMaintenance and Cleaning Internal CleaningExternal Cleaning Replace light bulbSymptom Solution Something not WorkingRefrigerant Circuit Technical TerminologyEvaporator Guarantee Conditions Regulations, Standards, GuidelinesCompressor CondenserEuropean Guarantee Service & Spare Parts Service & Spare PartsHelp us to help you Customer Care
Top Page Image Contents