Installation
Levelling
The appliance must be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance.
If required the washer (2) can be removed.
2 |
1 |
Reversing the Door
The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand.
Carefully tilt the appliance to the back and place an adequate object under it.
Take care to avoid the compressor or the condenser touching the
ground.
Unscrew both adjustable legs at the front.
Dismount the Lower door hinge at the bottom on the right side. To do this, unscrew the three screws, and pull the door holder down together with the door holder pin. Remove the screw on the left side, and screw it in on the right side.
Remove the door by pulling it downwards while keeping it slightly opened.
Unscrew the upper hinge pin, and screw it in on the opposite side.
Put the door back in its place.
10