Operating Instructions
...there are problems operating the dishwasher.
Symptom | Possible Cause | Solution | |
| The dishwasher door has not | Shut the door. | |
| been closed properly. | ||
|
| ||
| Mains plug is not | Insert mains plug. | |
The programme does | plugged in. | ||
| |||
|
| ||
not start. | House fuse is faulty. | Replace fuse. | |
| |||
| For dishwasher models with | If dishes are to be washed | |
| delay start timer: | immediately cancel delay | |
| Delay start has been selected. | start timer. | |
|
|
| |
| The washing compartment is | Only wash cutlery and dishes | |
| made of anticorrosive stain- | that are suitable for dish- | |
| less steel. Rust spots in the | washer use. | |
| washing compartment are |
| |
Spots of rust are visible | from particles from outside |
| |
in the washing com- | the appliance (rust particles |
| |
partment. | from the water pipe, from | Close the salt dispenser lid | |
| pans, cutlery, etc.). Remove | ||
| securely. | ||
| such spots with a commer- | ||
|
| ||
| cially available stainless steel |
| |
| cleaner. |
| |
There is a whistling | The whistling is not a cause | Use a different brand of | |
noise during washing. | for concern. | detergent. | |
|
|
|
...the wash results are unsatisfactory.
The dishes are still dirty.
–The wrong wash programme was selected.
–The dishes were arranged in such a way as to stop the water reaching all parts of the surface. The dish racks must not be overloaded.
–The filters in the base of the washing compartment are dirty or incor- rectly positioned.
–Too little or no detergent was used.
–Where there are limescale deposits on the dishes: the special salt con- tainer is empty or the water softener is incorrectly adjusted.
–The drain hose is connected wrongly.
The dishes are wet and dull.
–Rinse aid was not used.
–The rinse aid container is empty.
29