Electrolux 40660 i manual Electrical Connection, Changing a fuse

Page 38

Installation and Connection Instructions

Electrical Connection

	Any electrical work required to install this appliance should be car-
	ried out by a qualified electrician or competent person.
1	WARNING - This appliance must be earthed.
	The manufacturer declines any responsibility should these safety

measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are coloured in accordance with the following code.

Green

& Yellow

BlueBrown

Green and Yellow : Earth

Blue	: Neutral
Brown	: Live

Cord Clamp

•The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

•The wire coloured blue must be connected to the terminal “N“ or col- oured black.

•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.

38

Image 38

Contents Favorit 40660 Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Control panel NingArea where you live Prior to using for the first timeAdjusting the Water Softener PanelManual setting Be cancelled by pressing the appropriate buttonDishwasher must be switched off Electronic settingRemain illuminated Open the door, remove the lower Basket Filling with Salt for the Water SoftenerFill with dishwasher salt Turning it anticlockwiseAge the appliance Filling with Rinse AidOugh rinsing, spot and streak free drying Fill with rinse aidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherHazard Loading CutleryUpright position are a potential RackTo ease the loading of large items Loading Pans, Frying Pans Large PlatesFolded over to the left Two right-hand plate insertsTwo rear plate inserts in the lower Folded across one anotherAcross one another Baskets can be folded across one anotherLoading Cups, Glasses Coffee Services Filling with Detergent Fill with detergentUse of 3 in 1/ Combi Detergent Tablets General AdviceSpecial Advice Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table Type of SoilingWasher Start the wash programmeInterrupting or ending the wash programme Open the door carefullyChanging the delay start timer Setting or changing the delay start timerSetting the delay start timer Pause functionSive cleaners Care and CleaningSwitching Off the Dishwasher Emptying the DishwasherCleaning the Filter StancesFault warnings are displayed What to do, ifDishes are still dirty There are problems operating the dishwasherWash results are unsatisfactory Dishes are wet and dullThere are dried water drops on the glasses and dishes Technical DataDecrease rinse aid dosing Sample loading arrangements Upper basket Lower basket with cutlery basketInstallation and Connection Instructions Installing the DishwasherDishwashers That Can Be Integrated See installation template suppliedWith the following dimensions Permitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Page Page Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG