Electrolux 5070 Load Sensing Sensor Logic, Switching Off the Dishwasher, Emptying the Dishwasher

Page 23

Operating instructions

Cancelling the wash programme

0 1. Press the button for the current wash programme and hold it pressed. The programme indicator for the current wash programme flashes for a few seconds and then extinguishes.

2.Release the programme button, the wash programme is cancelled.

3	A selected programme is only interrupted by switching off the dish-
	washer, it is not cancelled. The wash programme is continued when the

dishwasher is switched on again.

Load Sensing – Sensor Logic

If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

Only switch off the dishwasher when END is illuminated on the pro- gramme progress display.

0 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes.

1	Hot steam may escape from the appliance when opening the door
	immediately after the end of the programme.

2.Open the door carefully, as steam may escape.

	Emptying the Dishwasher
3	• The dishes should be allowed to cool down before removing them
	from the appliance, as hot dishes can sensitive to knocks.

• The dishes will dry quicker if you open the door fully and then leave it slightly ajar, when the programme has finished.

• Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.

• First empty the lower rack, and then the upper rack. This will avoid any water that may be remaining in the upper rack, dripping onto the dishes in the lower rack and leaving water marks.

23

Image 23

Contents Ökofavorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions General safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Control Panel Prior to using for the first timeHardness range of the water in your area Adjust the Water SoftenerAdjust Number SaltOpen the door, remove the lower rack Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher saltFill with rinse aid Filling with Rinse AidOugh rinsing, spot and streak free drying Age the applianceReplace the lid and tighten by turn- ing clockwise Adjusting Rinse Aid DosingDaily Use Loading Cutlery and Dishes Loading Cutlery To ease the loading of large items at Loading Pans, Frying Pans and Large PlatesLoad large and heavily soiled dishes in the lower rack Loading Cups, Glasses Coffee Services Maximum Height of the Dishes Adjusting the Height of the Upper RackLowering the Upper Rack Raising the Upper RackTions given on the detergent packaging Filling with DetergentUse only dishwasher detergent Fill with DetergentDetergent Recommendations Bio Wash Programmes and Concentrated DetergentsSelecting the Wash Programme Programme Table Changing the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeEmptying the Dishwasher Switching Off the DishwasherCancelling the wash programme Load Sensing Sensor LogicCleaning the Filter Care and CleaningStances END and Drying on Error messagesSymptom Possible Cause Solution What to do, ifDishes are wet and dull There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyThere are dried water drops on the glasses and dishes Technical DataLower rinse aid dosing Bottom rack with cutlery basket An open-end spanner Screwdriver Installing the DishwasherFree-Standing Appliances Dishwashers That Can Be IntegratedBuilt-In Dishwasher Work surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressureSink outlet connection Water drainDrain hose Extension hosesChanging a fuse Leak Prevention SystemElectrical Connection Installation and Connection Instructions Connections Other Countries Israel Malaysia Saudi Arabia Cyprus Lebanon OmanEstonia Latavia Poland Hongkong Lthuania RussiaSyria HungaryGreat Britain Guarantee ConditionsEuropean Guarantee Otros puntos de Postventa en el extranjero Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Weitere Kundendienststellen im AuslandCalls may be recorded for training purposes 08705 929Customer Care