Electrolux 5070 manual Leak Prevention System, Electrical Connection, Changing a fuse

Page 35

Installation and Connection Instructions

 

Leak Prevention System

 

For protection from damage due to water leaks, the dishwasher is

 

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

 

In the event of a fault, the drain pump switches on. By this means

 

water can neither escape nor overflow. The remaining water in the

 

appliance is automatically pumped out.

1

The AQUA CONTROL SYSTEM also works when the appliance is switched

 

off – the appliance must however not be disconnected from the mains.

Electrical Connection

 

Any electrical work required to install this appliance should be car-

 

ried out by a qualified electrician or competent person.

1

WARNING - This appliance must be earthed.

 

The manufacturer declines any responsibility should these safety

measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are col- oured in accordance with the fol- lowing code.

Green

& Yellow

Blue

Brown

Green and Yellow : Earth

Blue

: Neutral

Brown

: Live

Cord Clamp

35

Image 35
Contents Ökofavorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions General safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Control Panel Prior to using for the first timeHardness range of the water in your area Adjust the Water SoftenerAdjust Number SaltOpen the door, remove the lower rack Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher saltFill with rinse aid Filling with Rinse AidOugh rinsing, spot and streak free drying Age the applianceReplace the lid and tighten by turn- ing clockwise Adjusting Rinse Aid DosingDaily Use Loading Cutlery and Dishes Loading Cutlery To ease the loading of large items at Loading Pans, Frying Pans and Large PlatesLoad large and heavily soiled dishes in the lower rack Loading Cups, Glasses Coffee Services Maximum Height of the Dishes Adjusting the Height of the Upper RackLowering the Upper Rack Raising the Upper RackTions given on the detergent packaging Filling with DetergentUse only dishwasher detergent Fill with DetergentDetergent Recommendations Bio Wash Programmes and Concentrated DetergentsSelecting the Wash Programme Programme Table Changing the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeEmptying the Dishwasher Switching Off the DishwasherCancelling the wash programme Load Sensing Sensor LogicCleaning the Filter Care and CleaningStances END and Drying on Error messagesSymptom Possible Cause Solution What to do, ifDishes are wet and dull There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyThere are dried water drops on the glasses and dishes Technical DataLower rinse aid dosing Bottom rack with cutlery basket An open-end spanner Screwdriver Installing the DishwasherFree-Standing Appliances Dishwashers That Can Be IntegratedBuilt-In Dishwasher Work surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressureSink outlet connection Water drainDrain hose Extension hosesChanging a fuse Leak Prevention SystemElectrical Connection Installation and Connection Instructions Connections Other Countries Israel Malaysia Saudi Arabia Cyprus Lebanon OmanEstonia Latavia Poland Hongkong Lthuania RussiaSyria HungaryGreat Britain Guarantee ConditionsEuropean Guarantee Otros puntos de Postventa en el extranjero Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Weitere Kundendienststellen im AuslandCalls may be recorded for training purposes 08705 929Customer Care