INSTALLATION INSTRUCTIONS
1.4 SIDEWALL (D) | 1.6 ASSEMBLING ON CASTORS |
(5)
(4)
a
b
Fig.2 Assemblage of sidewall
The assembly kit contains two of each of the following: hexagonal screws M8x25 (1 / Fig.1), bolts with retaining rings
(2 / Fig.1), mounting links (3 / Fig.1), hexagonal screws M8x16 with serrated washers and hexagonal nuts M8, hexagonal screws M5 with serrated washers (4 / Fig.2)
and a fastening angle (5 / Fig.2).
DInsert the bolts with the retaining rings (2 / Fig.1a) from out- side into the guide in the sidewall.
DKeeping the screw (1 / Fig.1a) loose, turn it until it is approximately 5 mm deep in the pre-assembled caged nuts in the sidewall.
DAttach the fastening angle (5 / Fig.2b) to the bottom of the frame using the screws, serrated washers and nuts.
D(4 / Fig.2).
DPosition the sidewall and screw it on from below using two hexagonal screws and the serrated washers.
DFit the mounting link (3 / Fig.1b) into the inside of the appli- ance's connecting plate.
DAlign the sidewall and firmly tighten all screws.
1.5STEEL PLINTH
a
b | c |
| |
|
|
Fig.4 Assemblage on castors
The assembly kit for mounting on castors contains two cross bars (2/Fig.4a) each with a fixed rear wheel (1/Fig.4a) and a turnable front wheel (3/Fig.4a).
Mounting the castors:
DPut the appliance on supports.
DRemove the feet; each is tightened with four screws (Fig.4b).
DBring the two cross bars into the correct position below the appliance and fasten it with 8 screws arrows (Fig.4a).
DRemove the supports.
DFasten the appliance to the building. Use the hole to attach a chain descending from the wall (arrow/Fig.4c). Making sure the chain is shorter than the gas and electric connec- tions.
Note:
Appliances on wheels must be secured by fasten it to the building.
(3)
| (2) b |
b | (1) |
|
a
(3)(1)
(2)
b
2.ACCESS TO INTERIOR
Note:
Only authorized technicians may access the interior.
C | E |
Fig. 3 Plinth assembly
To assemble the plinth you will need:
•Right and left side plinth (1 / Fig.3).
•Plinth for the front and, for
DPush the side plinth (1 / Fig.3) onto the legs from front to rear using the fastener. The larger gap (b / Fig.3) on the fastener must be at the bottom.
DAffix the fasteners (3 / Fig.3) to the plinth (2 / Fig.3).
DThe larger gap (b / Fig.3) on the fastener must be at the bottom.
DAttach the plinth with the fasteners (3 / Fig.3) onto the feet.
A
2 | 4 | B |
|
D 
D
1 | 1 | 5 | 5 | 3 3 |
Fig. 5 General view
62.9582.01_UL | Page 5 |