Removing the hood from the wall unit
If, for technical reasons (extraction version/recirculation version conversion) the extractor hood has to be removed from the wall unit, proceed as follows:
•Fully withdraw the visor and remove the grease filter.
•Loosen the 4 or 6 mounting screws of the hood (wall unit mounting).
•To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips
Fig. 14
Important: Hold the hood firmly!
Adjusting the extractor part (E - Fig. 1) - Fig. 15
On wall units with a body depth of 275 mm to 335 mm, the visor depth can be adjusted as follows:
•Remove both grease filters.
•Loosen the screws on both
•Refit the screws.
•Refit the grease filters.
Fig. 15
78