Emerson 3350 Wiring terminal labels, Connecting the Model 3700 to the sensor

Page 12

Figure 12. Wiring terminal labels

Model 3350/3700 with AC

Model 3350/3700 with DC

power supply

power supply

Terminal 9:

Terminal 9:

line

positive

(L or L2)

 

Terminal 10:

Terminal 10:

neutral

negative

(N or L1)

 

STEP 7. Connecting the Model 3700 to the sensor

If you are installing the Model 3350 applications peripheral, this step is not required. Go to Step 8.

To connect the Model 3700 transmitter to a Micro Motion sensor, follow the instructions in this section.

11

Image 12
Contents Model 3700 Transmitter MVD or Model 3350 Peripheral Before YOU Begin European installations Installation kitDimensions Choosing a locationEnvironmental requirements Visibility of tagsDimensions face view Dimensions conduit openings view Cable lengthsWire remote transmitter Maximum cable lengthsPreparing conduit openings for Atex Zone Orienting the Model 3350/3700 optionalMounting the applications platform Mounting to a flat surfaceConnecting input and output wiring Mounting the core processorWiring terminals Input/output wiring terminalsWiring terminal labels Connecting the Model 3700 to the sensorInstallation options Wiring instructions for 4-wire remote installationsWire cable to Model 3700 standard core processor Page Gland nut Shielded heat shrink completely covers exposed drain wires Reinstall and tighten the core processor lid Wire cable to core processor Connecting power supply wiring Page Page Page 20001008