Electrolux 55V installation instructions Connecting to GAS, Connection to the Electricity Supply

Page 37
Fig.3
All dimensions in mm

5.CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be less than R³/8 (³/8" B.S.P.). Connection is made to the Rc½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig.3. Take into account that it must be possible to pull the appliance forward sufficiently. The hose must not get caught on the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO 50mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

NOTE: ONLY LIQUID SEALANTS CAN BE USED IN THREADED GAS CONNECTIONS. DO NOT USE P.T.F.E. TAPE.

6. CONNECTION TO THE ELECTRICITY SUPPLY

WARNING: THIS APPLIANCE MUST BE EARTHED. DO NOT EARTH THIS APPLIANCE TO THE GAS SUPPLY PIPING.

This appliance must be connected to 230V-240V A.C. 50Hz supply. It is supplied with 2 metres of 5 amp 3 core cable incorporating a moulded 13 amp plug , fitted with a 3 amp fuse, which can be plugged directly into

the nearest suitable socket. Ensure the plug is accessible

to the user. If this is not long enough,Fig.4 the supply cable can be replaced totally by a longer

cable at least 0.75mm² nominal cross sectional area (24/0.2mm).

IF THE MOULDED PLUG IS CUT FROM THE CABLE

FOR ANY REASON, IT MUST BE DESTROYED OR

DISPOSED OF SAFELY, AS THE PROTRUDING

WIRES WILL BE AN ELECTRIC SHOCK HAZARD.

If any other type of plug is used it should incorporate a 3 amp fuse in either the plug or adapter or at the distribution board.

If the cable has to be threaded through small apertures in cabinets etc., it may be disconnected from the appliance, then re-connected to as shown in Fig.4.

DO NOT EXTEND THE CABLE USING PLASTIC OR CERAMIC CONNECTION TERMINAL BLOCKS AND/OR INSULATION TAPE.

ALL EXTERNAL WIRING BETWEEN THE APPLIANCE AND THE ELECTRICAL SUPPLY SHALL COMPLY WITH I.E.E. WIRING REGULATIONS.

37

Image 37
Contents Operating Installation Instructions Introduction For your safetyContents Grill and hotplate Lighting the applianceOven Open the oven doorOven light To turn off any burnerGrill control gives two heat settings Prior to using the grillGrill Heat controlPreheating Cooking positionsPositioning food on the grid Burner sizes HotplateFor your safety Helpful hints Heat zones OvenOven Shelves Roasting Baking trays and dishes For your safetyCondensation Oven cooking chart Mins. per ½ kg 1lb and 15 mins Mins. per ½ kg 1lb and 25 mins10 15 minutes cooking time for each ½ kg 1lb ¼-2½ hoursMins Cooking Yeast MixturesMins Rolls and buns Food preparation slow cooking Slow cookingCover food with a tight fitting lid or tin foil Do not cook casseroles over 2.7 kg 6lbThaw thoroughly before cooking Care and cleaning For your safety Hotplate When replacing hotplate burner partsGrill Oven roof Boil overFat splashing Going to roast. If they are wetGeneral Oven cleaning cycleCleaning The Door Glass Location Installing the applianceFor further details see Positioning Appliance dimensionsOverall height 1460mm Height to hotplate 902mm 920mm Width 554mm DepthConnecting to the electricity supply General information For your safetyMoving your appliance Replacing the oven light bulb StorageCheck What is wrong and why?What is wrong and why? 7 0 5 9 2 9 9 2 Service and spare partsServicing Installation Instructions Connections DimensionsGrill Provision for Ventilation Important Safety RequirementsLocation of Appliance Grill AssemblyParts Required Fitting the Stability Bracket Levelling the ApplianceConnection to the Electricity Supply Connecting to GASChecking the Grill Pressure TestingChecking the Main Oven Checking the HotplateChecking the Oven Light General NoteT E S T E S Lyric 55V Contents Check List Telephone 0870 5 Part Number311629502 Important Notice