Electrolux EKG6047, EKG6046 Levelling the appliance, Connecting to the electricity supply

Page 22

22electrolux

It is essential that the appliance is positioned as Fig 1. a.

Shelves, wall cabinets and cooker hoods must be fitted a minimum of 750mm directly above the top of the hotplate (or greater for cooker hoods if recommended by manufac- turers instructions) and 400mm above the hotplate when fitted in line with the outside of the appliance.

If the units are intended to be fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 50mm must be maintained between the sides of the unit and the appliance as Fig 1.b. Curtains must not be fitted immediately be- hind the appliance or within 150mm of the sides of the hotplate.

If fitted next to or between two base units a minimum space of 2mm must be left be- tween each unit and the sides of the appli- ance.

The levelling feet fitted to the appliance will achieve a nominal height to hotplate of 907mm + / - 5mm.

Fig 1.a

Fig 1.b

L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any boat, yacht or other vessel.

Levelling the appliance

Adjustment to suit floor conditions or height is obtained by rotating clockwise or anti clockwise the feet at the front and rear of the appliance.

A spirit level should be placed on one of the shelves to confirm the appliance is correctly levelled.

Connecting to the electricity supply

Warning! This appliance must be earthed. Do not earth this appliance to the gas supply piping. Connect to 230 - 240V AC supply only.

Connection to the electricity supply should be made via a properly earthed, readily ac- cessible wall socket. Which is adjacent to, but not directly above and not more than 1.7m away from the appliance and capable of electrical isolation.

The cooker point should be within 1.7m of the appliance to make it accessible to switch off the appliance in case of emergency. The mains lead should be routed so that it cannot touch hot parts of the cooker i.e. the back panel above a height of 650mm from the floor. Should this plug not fit the socket outlet in your home it should be cut off and replaced with a suitable plug as outlined be- low.

If the supply cord is damaged, it must be re- placed. Please contact your local Service Force Centre.

If the moulded plug is cut from the cable for any reason it must be destroyed or disposed of safely, as protruding wires will be an elec- trical shock hazard.

If the fitted plug is removed.

The flexible mains lead must be correctly connected as below to three pin plug of not less than 13amp capacity.

If a B.S. 1363 fused plug is used, it must be fitted with a 3 amp fuse which is approved to B.S. 1362.

Important: The wires in the mains lead fitted to the appliance are coloured in accordance with the following code.

GREEN AND YELLOW = EARTH

BLUE = NEUTRAL

BROWN = LIVE

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the termi- nals in your plug, proceed as follows:- The wire which is coloured green and yellow must be connected to the terminals in the plug which is marked with the letter E or by the earth symbol ( ) or coloured green or green and yellow.

Image 22
Contents Cooker EKG6046 EKG6047Electrolux. Thinking of you Contents Safety informationCare and cleaning Appliance Product descriptionControl panel Grill and oven furnitureBefore first use Operation To return the appliance to manual To set the timer to switch off onlyTo cancel an automatic programme Things to noteTo turn off any burner Using the grillTo light the hob burners GrillTo attach the handle Using the top ovenGrill pan handle To remove the handleTo fit the top oven shelf Using main oven conventional cookingMain oven conventional cooking Heat zones Slow Cook Using slow cookMain oven shelves Food preparation Slow cook Joints of meat and poultryHelpful hints and tips Top oven cooking chart Grilling chartCooking tables Food Shelf position Gas mark Main oven cooking chartHours Food Shelf position Gas mark Cleaning materials Care and cleaningRoasting chart Cleaning the outside of the applianceWhen replacing hob burner parts Removing and replacing the wire work runnersCleaning the gas hob Cleaning the grillCleaning the doors Cleaning inside the grill and oven compartmentsCleaning between the outer and inner door glass What to do if… ProblemPossible solution To replace the inner door glassProblem Possible solution Installation instructions Levelling the appliance Connecting to the electricity supplyIf the fitted plug is removed LPG Flexible connections must be a type suitable for Connecting to the gas supplyIf a moulded plug is fitted Fitting the stability chainChecking the lid shut-off device Pressure testingChecking the hob Checking the grillTechnical data GB IE Guarantee/Customer Service Environment concernsTel +353 01 4090751, Email serv- ice.eid@electrolux.ie Customer CareTraining purposes 349171300-G-072009