Electrolux K 7 18 40 - 1i installation instructions Instructions for building-in

Page 20

Instructions for building-in

Apply joint the sealing strip as shown in figure.

An additional midpoint location bracket may be fitted to the appli- ance (as shown) to assist retention of the housing side wall.

Drill the unit using a ∅ 2,5 mm drill (10 mm max. penetration.

Fix the square fitting (1) to the appli- ance.

Push appliance into the housing until stop strip (A) touches the kitchen unit.

D765

Ø 2,5

13mm

D740

A

D015/1

20

Image 20

Contents Santo K 7 18 40 Dear customer Who thinks ecologically acts accordinglyContents Safety Safety of childrenIntended use Prior to initial start-upService DisposalDaily Operation Appliance Packaging InformationRemove transport packaging Disposal of old AppliancesStarting up and temperature regulation Setting 0 OffInterior Accessories Fresh food refrigerationStorage Shelves Variable Inner DoorFreezing and storing frozen food Preparation of Ice Cubes DefrostingSwitching off the appliance Cleaning and CareCleansers which contain acetic acid Energy Saving TipsSymptom Possible Cause Remedy Something Not WorkingChanging the light bulb Put the refrigerator back into operationCustomer Care Department Service and Spare Parts0870 5 Guarantee Conditions Guarantee ConditionsInstallation Electrical ConnectionReversing the door PositioningYour appliance needs air Housing dimensions Inner door reversalHeight DepthInstructions for building-in Apply joint the sealing strip as shown in figureApply covers B into the relevant holes Separate parts A, B, C, D as shown in the figureFix cover C on guide a until it clips into place Regulations, Standards, Guidelines Fix cover D on guide B until it clips into place2222