Electrolux K 7 18 40 - 1i Changing the light bulb, Put the refrigerator back into operation

Page 14

If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre.

In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it. Light bulb data: 220-240 V, max. 15 W

1.To switch off the appliance, turn the temperature control knob to position "0".

2.Unplug the mains plug.

3.To change the light bulb, remove the screw from the light bulb cover.

4.Unhook the light bulb cover as shown.

5.Change the defective light bulb.

6.Refit the light bulb cover and the screw.

AEG65

7.Put the refrigerator back into operation.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Santo K 7 18 40 Dear customer Who thinks ecologically acts accordinglyContents Intended use SafetySafety of children Prior to initial start-upDaily Operation ServiceDisposal Appliance Packaging InformationRemove transport packaging Disposal of old AppliancesStarting up and temperature regulation Setting 0 OffStorage Shelves Interior AccessoriesFresh food refrigeration Variable Inner DoorFreezing and storing frozen food Preparation of Ice Cubes DefrostingSwitching off the appliance Cleaning and CareCleansers which contain acetic acid Energy Saving TipsSymptom Possible Cause Remedy Something Not WorkingChanging the light bulb Put the refrigerator back into operationCustomer Care Department Service and Spare Parts0870 5 Guarantee Conditions Guarantee ConditionsInstallation Electrical ConnectionReversing the door PositioningYour appliance needs air Height Housing dimensionsInner door reversal DepthInstructions for building-in Apply joint the sealing strip as shown in figureApply covers B into the relevant holes Separate parts A, B, C, D as shown in the figureFix cover C on guide a until it clips into place Regulations, Standards, Guidelines Fix cover D on guide B until it clips into place2222
Top Page Image Contents