Electrolux K 7 18 40 - 1i installation instructions Regulations, Standards, Guidelines

Page 23

At the end of installation/adjusting, it is necessary to check if the door of the furniture closes properly.

Should adjustment of the furniture door be necessary, use the clearance slots.

PR168

Fix cover (D) on guide (B) until it clips into place.

B

D

PR167/1

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regu- lations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance.

The refrigerant circuit has been checked for leaks.

This appliance is in accordance with the following EU guidelines:

– 73/23/EWG dated 19 February 1973 - low voltage guidelines.

– 89/336/EWG dated 3 May 1989

(including guideline change notice 92/31/EWG) - EMV guideline

23

Image 23
Contents Santo K 7 18 40 Who thinks ecologically acts accordingly Dear customerContents Prior to initial start-up SafetySafety of children Intended useAppliance Packaging Information ServiceDisposal Daily OperationDisposal of old Appliances Remove transport packagingSetting 0 Off Starting up and temperature regulationVariable Inner Door Interior AccessoriesFresh food refrigeration Storage ShelvesFreezing and storing frozen food Defrosting Preparation of Ice CubesCleaning and Care Switching off the applianceEnergy Saving Tips Cleansers which contain acetic acidSomething Not Working Symptom Possible Cause RemedyPut the refrigerator back into operation Changing the light bulbCustomer Care Department Service and Spare Parts0870 5 Guarantee Conditions Guarantee ConditionsElectrical Connection InstallationReversing the door PositioningYour appliance needs air Depth Housing dimensionsInner door reversal HeightApply joint the sealing strip as shown in figure Instructions for building-inSeparate parts A, B, C, D as shown in the figure Apply covers B into the relevant holesFix cover C on guide a until it clips into place Fix cover D on guide B until it clips into place Regulations, Standards, Guidelines2222