Electrolux U31462 operating instructions Appliance Alignment, Electrical Connection, Earth

Page 10

Installation

Remove the two wall spacers from the appliance accessories pack and, in accordance with the illustrations, fix them at the top of the rear of the appliance so that the distance from the wall required for the necessary ventilation is ensured.

Appliance Alignment

01. The appliance must be level. Please compensate for unevenness in the floor by turning the two adjustable feet at the front.

Electrical Connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

1 WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety measures not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.

Important

The wires in the mains lead are coloured in accordance with the follow- ing code:

Green and Yellow	Earth		Green
Green and Yellow	Earth		& Yellow
Blue	Neutral
Brown	Live
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings indentifying the termi-		Blue	Brown

nals in your plug, proceed as fol- lows:

Cord Clamp

10	818 35 94-01/2

Image 10

Contents Arctis Dear customer Contents Cooling drinks What to do ifInstallation Important Safety InstructionsPrior to Installation RefrigerantDuring Use Child SafetyMaintenance and Cleaning ServicingPackaging material Environmental InformationAppliance Transport Old appliancePackaging Before UseFitting the Door Handle Dle bracket on the lower left-hand side of the doorA higher power consumption see also Something not working InstallationInstallation Location Freezer needs ventilationEarth Appliance AlignmentElectrical Connection Nals in your plug, proceed as fol- lowsReversing the door Right. Close the doorMove the upper hinge bracket pivot to the left Reversing the door No-frost frost free system View of the appliance Description of the applianceCold accumulation block These buttons are connected to the temperature display Temperature setting buttonsControl Panel Temperature display Alarm OFF button TURBO/FROSTMATIC-buttonInitial use Prior to Initial Start-UpRemove the cold accumulation block from the appliance Temperature Adjustment Select Freezing or CoolingSwitching the Appliance Off Control and Information Systems Temperature WarningRed warning indicator will go out when the door is closed Open Door WarningFunction Errors Temperature memoryOpening the door Only in the operating mode Freezing FreezingPreparation of Ice Cubes Frozen StorageTips Cooling Storage Goods Symbols/Freezing CalendarMaximum Load Long Fresh CoolingStandard Cooling Cooling drinksNormal Operating Sounds Energy Saving AdviceHints and Tips Food StorageInternal Cleaning Maintenance and CleaningExternal Cleaning What to do if Correcting MalfunctionsWhat to do if Replace defective light bulb Place the cover again Regulations, Standards, GuidelinesReplacing the light bulb Refrigerant circuit has been checked for leaksEvaporator Technical TerminologyRefrigerant Circuit CompressorGuarantee Conditions Standard Guarantee ConditionsCustomer Care Service & Spare Parts08705 929 Major AppliancesSubject to change without notice