Electrolux U31462 operating instructions Select Freezing or Cooling, Temperature Adjustment

Page 20

Select "Freezing" or "Cooling"

If necessary, switch over the appliance with the following steps between the operating modes "Freezing" and "Cooling":

01. Hold down the ALARM OFF button and the „-“ (COLDER) button simul- taneously for 5 seconds.

When the setting is switched from “Freezing” to “Cooling” “FC” (Freezing -> Cooling) appears in the temperature display, an acoustic signal confirms the change and the temperature display changes to flashing figures (DESIRED temperature cooling mode +5 °C). Using the temperature setting buttons, the required temperature for the cooling mode can now be entered.

When the setting is switched from “Cooling” to “Freezing” “CF” (Cool- ing -> Freezing) appears in the temperature display, an acoustic sig- nal confirms the change and the temperature display changes to flashing figures (DESIRED temperature freezing mode -18 °C). Using the temperature setting buttons, the required temperature for the freezing mode can now be entered.

3 The operation mode, in which your appliance is at the moment, is identifiable if the temperatures can be set above or below 0 °C.

2.Set the temperature depending upon the selected operation mode (see the chapter "Temperature Adjustment").

Attention! If you are using the appliance as a freezing unit: Please wait prior to putting the foodstuff to be frozen, until the freezer interior temperature has attained -18 °C, or until the red warning display goes off.

Attention! If you are using this appliance as a cooling unit, after it has been used as a freezing unit: Please wait until the temperature has reached 0 °C before putting the foodstuff to be cooled in the appliance.

Temperature Adjustment

01. Press either the „+“ (WARMER) or „-“ (COLDER) button.

The temperature display switches over and the DESIRED temperature currently set flashes on the temperature display.

2.To adjust to a warmer temperature, press the „+“ (WARMER) button. To adjust to a colder temperature, press the „-“ (COLDER) button. The changed setting is immediately displayed on the temperature display.

20

818 35 94-01/2

Image 20
Contents Arctis Dear customer Contents Cooling drinks What to do ifImportant Safety Instructions Prior to InstallationInstallation RefrigerantChild Safety Maintenance and CleaningDuring Use ServicingEnvironmental Information Appliance TransportPackaging material Old applianceBefore Use Fitting the Door HandlePackaging Dle bracket on the lower left-hand side of the doorInstallation Installation LocationA higher power consumption see also Something not working Freezer needs ventilationAppliance Alignment Electrical ConnectionEarth Nals in your plug, proceed as fol- lowsReversing the door Right. Close the doorMove the upper hinge bracket pivot to the left Reversing the door No-frost frost free system Cold accumulation block Description of the applianceView of the appliance Control Panel Temperature setting buttonsThese buttons are connected to the temperature display Temperature display Alarm OFF button TURBO/FROSTMATIC-buttonRemove the cold accumulation block from the appliance Prior to Initial Start-UpInitial use Temperature Adjustment Select Freezing or CoolingSwitching the Appliance Off Temperature Warning Red warning indicator will go out when the door is closedControl and Information Systems Open Door WarningOpening the door Temperature memoryFunction Errors Only in the operating mode Freezing FreezingTips Frozen StoragePreparation of Ice Cubes Storage Goods Symbols/Freezing Calendar Maximum LoadCooling Long Fresh CoolingStandard Cooling Cooling drinksEnergy Saving Advice Hints and TipsNormal Operating Sounds Food StorageExternal Cleaning Maintenance and CleaningInternal Cleaning What to do if Correcting MalfunctionsWhat to do if Regulations, Standards, Guidelines Replacing the light bulbReplace defective light bulb Place the cover again Refrigerant circuit has been checked for leaksTechnical Terminology Refrigerant CircuitEvaporator CompressorGuarantee Conditions Standard Guarantee ConditionsService & Spare Parts 08705 929Customer Care Major AppliancesSubject to change without notice