Electrolux U31462 Regulations, Standards, Guidelines, Replacing the light bulb

Page 32

Malfunction

Possible cause

Remedy

Only temperatures above

 

Selecting the operation

 

mode "Freezing". For that,

0 °C can be set, although

The appliance is in the

please refer in the "Select

the appliance should be

operation mode "Cooling".

Freezing or Cooling"

used as a freezing unit.

 

 

chapter.

 

 

Only temperatures below

 

Select the operation mode

0 °C can be set, although

The appliance is in the

"Cooling". For that, please

the appliance should be

operation mode "Freezing".

refer in the chapter "Select

used as a cooling unit.

 

Freezing or Cooling".

 

 

 

Replacing the light bulb

1 Warning! Danger of electrical shock! Before replacing the light bulb switch appliance off and remove the mains plug, or switch off or disconnect from the electricity supply.

Light bulb specifications: 220-240 V, max. 25 W, socket: E 14

01. To switch the appliance off press

and hold the ON/OFF button for approximately 1 second.

2. Remove mains plug.

3. For replacement of the light bulb press the cover and remove it like shown on the illustration.

4.Replace defective light bulb.

5.Place the cover again.

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), acci- dent prevention regulations for refrigeration appliances (VBG 20) and the regulations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance.

The refrigerant circuit has been checked for leaks.

32

818 35 94-01/2

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Arctis Dear customer Contents Cooling drinks What to do ifImportant Safety Instructions Prior to InstallationInstallation RefrigerantChild Safety Maintenance and CleaningDuring Use ServicingEnvironmental Information Appliance TransportPackaging material Old applianceBefore Use Fitting the Door HandlePackaging Dle bracket on the lower left-hand side of the doorInstallation Installation LocationA higher power consumption see also Something not working Freezer needs ventilationAppliance Alignment Electrical ConnectionEarth Nals in your plug, proceed as fol- lowsReversing the door Right. Close the doorMove the upper hinge bracket pivot to the left Reversing the door No-frost frost free system Cold accumulation block Description of the applianceView of the appliance Control Panel Temperature setting buttonsThese buttons are connected to the temperature display Temperature display Alarm OFF button TURBO/FROSTMATIC-buttonRemove the cold accumulation block from the appliance Prior to Initial Start-UpInitial use Temperature Adjustment Select Freezing or CoolingSwitching the Appliance Off Temperature Warning Red warning indicator will go out when the door is closedControl and Information Systems Open Door WarningOpening the door Temperature memoryFunction Errors Only in the operating mode Freezing FreezingTips Frozen StoragePreparation of Ice Cubes Storage Goods Symbols/Freezing Calendar Maximum LoadCooling Long Fresh CoolingStandard Cooling Cooling drinksEnergy Saving Advice Hints and TipsNormal Operating Sounds Food StorageExternal Cleaning Maintenance and CleaningInternal Cleaning What to do if Correcting MalfunctionsWhat to do if Regulations, Standards, Guidelines Replacing the light bulbReplace defective light bulb Place the cover again Refrigerant circuit has been checked for leaksTechnical Terminology Refrigerant CircuitEvaporator CompressorGuarantee Conditions Standard Guarantee ConditionsService & Spare Parts 08705 929Customer Care Major AppliancesSubject to change without notice
Top Page Image Contents