Electrolux U31462 operating instructions Prior to Initial Start-Up, Initial use

Page 19

Prior to Initial Start–Up

1 Before connecting the appliance to the mains and putting it into oper- ation for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 2 hours before putting it into operation. This is nec- essary to allow the refrigerant to flow back into the compressor. Other- wise the compressor may be damaged.

01. Please clean the appliance interior and all accessories prior to initial start-up (see section: “Maintenance and Cleaning”).

2.The appliance must be correctly installed in accordance with the chap- ter "Installation" before it is put into operation for the first time. Care should be especially taken that the mains voltage and frequency avail- able correspond with the appliance’s rating plate.

3.Remove the cold accumulation block from the appliance.

4.Only put the cold accumulation block to freeze in the top compartment after the optimal storage temperature of –18 °C has been reached.

5.After 24 hours place the cold accumulation block in the uppermost compartment, at the front, above the frozen food.

6.Re-freeze the thawed cold accumulation block in the same way, e. g. after cleaning the appliance.

Initial use

01. Insert plug into mains socket.

2.Press ON/OFF button. The green pilot light illuminates.

A warning tone sounds and the red warning light flashes indicating that the required storage temperature has not yet been reached.

3.Press the ALARM OFF button to switch off the warning tone.

4.Set temperature to -18°C or colder (see section: "Temperature Adjust- ment").

Important! Wait until the freezer compartment has reached a tempera- ture of –18 °C, or the red warning light has gone out, before storing frozen food.

3 In the delivery state, your appliance is present in the operation mode "Freezing".

If the appliance was once in operation, it restarts in the operation mode, which was set prior to switching off.

818 35 94-01/2

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Arctis Dear customer Contents What to do if Cooling drinksRefrigerant Important Safety InstructionsPrior to Installation InstallationServicing Child SafetyMaintenance and Cleaning During UseOld appliance Environmental InformationAppliance Transport Packaging materialDle bracket on the lower left-hand side of the door Before UseFitting the Door Handle PackagingFreezer needs ventilation InstallationInstallation Location A higher power consumption see also Something not workingNals in your plug, proceed as fol- lows Appliance AlignmentElectrical Connection EarthRight. Close the door Reversing the doorMove the upper hinge bracket pivot to the left Reversing the door No-frost frost free system View of the appliance Description of the applianceCold accumulation block These buttons are connected to the temperature display Temperature setting buttonsControl Panel Temperature display TURBO/FROSTMATIC-button Alarm OFF buttonInitial use Prior to Initial Start-UpRemove the cold accumulation block from the appliance Select Freezing or Cooling Temperature AdjustmentSwitching the Appliance Off Open Door Warning Temperature WarningRed warning indicator will go out when the door is closed Control and Information SystemsFunction Errors Temperature memoryOpening the door Freezing Only in the operating mode FreezingPreparation of Ice Cubes Frozen StorageTips Long Fresh Cooling Storage Goods Symbols/Freezing CalendarMaximum Load CoolingCooling drinks Standard CoolingFood Storage Energy Saving AdviceHints and Tips Normal Operating SoundsInternal Cleaning Maintenance and CleaningExternal Cleaning Correcting Malfunctions What to do ifWhat to do if Refrigerant circuit has been checked for leaks Regulations, Standards, GuidelinesReplacing the light bulb Replace defective light bulb Place the cover againCompressor Technical TerminologyRefrigerant Circuit EvaporatorStandard Guarantee Conditions Guarantee ConditionsMajor Appliances Service & Spare Parts08705 929 Customer CareSubject to change without notice
Top Page Image Contents