Onkyo SKF-340F, SKC-340C Crossover Frequency, Double Bass, Advanced Setup-Continued, Use the Down

HT-S590_En.book Page 53 Wednesday, February 1, 2006 4:26 PM

Advanced Setup—Continued

Crossover Frequency

This setting only applies to the speakers that you speci- fied as Small in the “Speaker Configuration” on page 52. To get the best bass performance from your speaker sys- tem, you need to set the crossover frequency according to the size and frequency response of your speakers.

7	Use the Down [	] button to
	select “Crossover,” and then use
	the Left and Right [ ]/[ ] but-
	tons to select a crossover fre-
	quency.
	Use the diameter of the smallest
	speaker in your system when choosing
	the crossover frequency.
	Speaker cone	Crossover
	diameter	frequency
	Over 8 in.	40/50/60Hz*
	(20 cm)
	6-1/2 to 8 in.	80Hz
	(16–20 cm)
	5-1/4 to 6-1/2 in.	100Hz (default)
	(13–16 cm)
	3-1/2 to 5-1/4 in.	120Hz
	(9–13 cm)
	Under 3-1/2 in.	150/200Hz*
	(9 cm)
	*Choose the setting suitable for the speaker.

Continue with step 8 of the “Double

Bass” setting below.

8	Use the Down [ ] button to
	select “Double Bass,” and then

use the Left and Right []/[ ] buttons to select:

On: Double Bass function on. Bass from the front left and right channels is also fed to the subwoofer (default).

Off: Double Bass function off.

9	Press the [SETUP] button.
	Setup closes.
	When you want to go back up one
SETUP	menu level to “SP Config,” press the
	[RETURN] button.

Notes:

•For a more accurate setting, look up the frequency response in the manuals supplied with your speakers and set accordingly.

•Choose a higher crossover frequency if you want more sound from your subwoofer.

Double Bass

With the Double Bass function, you can boost bass out- put by feeding bass sounds from the front left and right channels to the subwoofer. This function can be set only if the Subwoofer setting (step 3) is set to Yes, and the Front setting (step 4) is set to Large in the Speaker Con- figuration on page 52.

53