2. INSTALLATION
LOCATION C (fig. 6)
Check that the outgoing electrical connections from the terminal strip are tight.
3.
Refit side cover of the compressor compartment into position refixing the screws holding the side cover (fig. 7)
4.
INSTALL firmly the appliance on a level floor, preferably on wooden blocks or on a wooden platform to protect it from damp and dirt. (fig. 8)
Fig 6.
Fig 7. |
Leave sufficient space on all sides of the appliance, keep it away from the walls for good circulation of air around it, see below:
Back and left side should be | Fig 8a. |
| |
minimum 3 cm away from the walls |
|
(fig. 8a) |
|
Hinges can be pushed against the wall.
Right side should be minimum 10 cm away from the wall (fig. 8b)
5.
The appliance has 4 supporting legs. If the appliance is not in a level and stable position, adjust this by adding wooden blocks or similar under the legs.
Fig 8.
Fig 8b.
7