3. HOW TO USE
3. CONTROL PANEL
The green light is illuminated as long as the freezer is connected.
The yellow light is illuminated when the „Super” button is depressed.
The red light is illuminated when the temperature in the freezer is higher than the thermostat setting.
The red alarm light can be due to:
Insertion of a large amount of vaccine/icepack. The red alarm light will go out after a while.
Opening the lid too long. The red alarm light will go out after a while.
A defect in the system. See under „TROUBLE SHOOTING”
Thermostat button |
|
Yellow light | Green light |
Red alarm light |
|
SUPER button | Fig 11. |
|
4. OPENING/CLOSING THE LID
The lid is fitted with a tightly closing sealing strip to prevent moisture getting inside the freezer and increasing the amount of frost formed. When the lid is opened the air inside the freezer becomes slightly warmer and expands. As soon as the lid is closed again the air is cooled immediately. This may lead to the creation of a vacuum which makes it hard to open the lid immediately after it has been closed. This is quite normal. Wait a few minutes until the vacuum has disappeared, then open the lid by pulling gently. Never pull the handle violently.
5.
Allow the appliance to run. The temperature inside the cabinet will be indicated on the thermometer on the front side. Observe the temperature from time to time (fig.12)
6.
Initially the temperature inside the appliance will be similar to, or slightly below, the room temperature. It should decrease slowly and should remain steady within a small range, after
Fig 12. |
9