Electrolux 70322 KG manual Prior to Initial Start-Up, Alarm OFF button

Page 21

ALARM OFF button

With the ALARM OFF button, the acoustic warning signal can be switched off, e.g. the "Open Door" warning when

sorting in or out, the food to be chilled or frozen.

When there is a temperature warning for the freezer compartment, if the ALARM OFF button is activated, the temperature display will show the warmest temperature the frozen food has reached.

Prior to Initial Start-Up

1 Before connecting the appliance to the mains and putting it into ope- ration for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 2 hours before putting it into operation. This is necessary to allow the oil to flow back into the compressor. Otherwise the compressor may be damaged.

01. Please clean the appliance interior and all accessories prior to initial start-up (see section: "Maintenance and Cleaning").

2.The appliance must be correctly installed in accordance with the chap- ter "Installation" before it is put into operation for the first time. Care should be especially taken that the mains voltage and frequency avail- able correspond with the appliance’s rating plate.

3.Remove the cold accumulation block from the appliance.

4.Place the cold accumulation block into a drawer only after the optimal storage temperature of -18 °C has been reached, and allow to freeze.

5.After 24 hours place the cold accumulation block at the front of the upper drawer.

6.Re-freeze the thawed cold accumulation block in the same fashion, e.g. after cleaning the appliance.

818 35 28-00/2

21

Image 21

Contents Santo 70322 KG Dear customer Contents Bottle Holder What to do ifPrior to Installation Important Safety InstructionsInstallation RefrigerantMaintenance and Cleaning Child SafetyDuring Use ServicingEnvironmental Information When disposing of your old applianceAppliance Transport PackagingBefore Use Remove the transport fittings from the storage shelves Installation Location InstallationAppliance Alignment Refrigerator/freezer needs ventilationWire coloured green Yellow must be connected to Electrical ConnectionTerminals in your plug, proceed Reversing The Door Cover on the plinth from the left to the rightBearing downwards Unscrew the centre door bearing Left as far as it will go Open the freezer compartment door and fit the plinth View of Appliance Appliance DescriptionCold Accumulation Block Control Panel Temperature Displays Temperature setting buttonsThese buttons are connected to the temperature display Temperature displays shows several types of informationPrior to Initial Start-Up Alarm OFF buttonSorting in or out, the food to be chilled or frozen Remove the cold accumulation block from the applianceInsert plug into mains socket Press the ON/OFF button Initial Start-UpTemperature Adjustment COOLMATIC/FROSTMATIC Switching the Appliance Off Switching off the refrigerator onlyIf the appliance is not to be used for an extended period Holiday Mode Control and Information Systems Temperature WarningOpen Door-Warning For the fridgeFunction Errors Opening the Freezer Compartment DoorFor the freezer Storage Shelves Interior AccessoriesVariable Inner Door Bottle rackBottle Holder Correct storage Freezing Storage Goods Symbols/Freezing Calendar Frozen StorageTips Defrosting Preparation of Ice CubesRefrigerator is defrosted automatically Freezer Compartment DefrostingHints and Tips Normal Operating SoundsFood Storage Energy Saving Advice Maintenance and CleaningInternal Cleaning External CleaningAfter everything is dry place appliance back into service Replacing the light bulb What to do if Symptom SolutionRefrigerant circuit has been checked for leaks Regulations, Standards, GuidelinesRefrigerant Circuit Technical TerminologyEvaporator CompressorStandard Guarantee Conditions Guarantee Conditions08705 929 Service & Spare PartsCustomer Care Calls may be recorded for training purposesSubject to change without notice