Replacing the Oven Light

Disconnect the appliance.

If the oven bulb needs replacing, it must comply with the following specifications:

- Wattage power: 15W,

- Voltage: 230V (50 Hz),

-Resistant to temperatures of 300°C,

-Connection type: E14.

These bulbs are available from your local Service

Force Centre.

To replace the faulty bulb:

1. Ensure the oven is disconnected from the

electrical supply.

2. Turn the glass cover anticlockwise.

3. Remove the faulty bulb and replace with the new one.

4. Refit the glass cover.

5. Reconnect to the electrical supply.

Something Not Working

If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force Centre.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

	SYMPTOM	SOLUTION
	The gas oven burner or the gas grill burner do not	Check that the oven is switched on at the wall
	light	Check that the power supply has not been interrupted
		before the cooling fan has had time to cool the oven
		down
		Check that there is not a problem with your gas
		supply

	Food is cooking too quickly or too slowly	Check that you are using the recommended tempe-
	Food is cooking too quickly or too slowly	rature settings and shelf positions.
		rature settings and shelf positions.

	The oven is not cooking evenly	Check that the oven is installed properly.
		Check that you are using the recommended tempe-
		rature settings and shelf positions.

	The oven light does not work	Check the light bulb, and replace it if necessary (see
		"Replacing the Oven Light")
	Steam and condensation settle on the food and	Refer to the contents of this booklet, especially to
	Steam and condensation settle on the food and	the chapter “Using the Gas Oven”.
	the oven cavity.	the chapter “Using the Gas Oven”.
	the oven cavity.	Leave dishes inside the oven no longer than 15-20
		Leave dishes inside the oven no longer than 15-20
		minutes after the cooking is completed.

If after all these checks, your hob still does not operate correctly, contact your local Electrolux Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.