Replacement of gas grill burner injector
To replace the gas grill burner injector, follow this proce- dure:
2.Undo the two fixing screws (“A”) which keep the oven gas burner in place
3.Gently slide the gas grill burner off its slot and slowly move it downwards, taking care not to cause stress to the spark plug connection wire (“B”) and the thermocouple (“D”) conductor;
3.With a 7 mm socket spanner unscrew and remove the gas grill burner injector (“C”), and replace it with the required one (see Table on this page);
4.Reassemble the burner following the same procedu- re backwards.
The gas grill burner does not require any primary air regulation.
Replacement of Gas Type Label
Once both the injectors for the gas oven burner and the gas grill burner have been replaced, take the Gas Type Label which is relevant to the new gas type and place it over the old one (it is located near the gas connection ramp). The replacement label is supplied with the injector kit.
Gas Grill Burner Data
B C D
GAS | INJECTOR | NOMINAL | NOMINAL GAS | REDUCED | NOMINAL | |
TYPE | MARK | GAS | FLOW IN | GAS | NEEDLE | GAS |
| 1/100 mm | POWER |
| POWER | (1/100 mm) | PRESSURE |
| m3/h g/h | |||||
|
| (kW) | (kW) |
| (mbar) |
Natural Gas | 098 | 1,9 | 0,181 | - | - | - | 20 | |
(G20) | ||||||||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
LPG | 71 | 1,9 | - | 138 | - | - | ||
(G30/G31) | ||||||||
|
|
|
|
|
|
|