Electrolux 241540105 (0612) manual Ice Dispenser

Dispenser will not dispense ice.

•Water supply is not connected.

•Ice storage container is empty.

•Freezer temperature is set too warm.

•Household water line valve is not open.

•Connect water supply (see page 9).

•When the first supply of ice is dropped into the container, the dispenser should operate.

•Turn freezer control to a higher setting so that ice cubes will be made. When first supply of ice is made, dispenser should operate.

•Open household water line valve. Allow sufficient time for the ice to be made. When ice is made, the dispenser should operate.

•Freezer door is not closed.

•Ice dispensing arm has been held in for more than 4-5 minutes.

•Ensure freezer door is closed.

•Motor is overloaded. Motor overload protector will reset in approximately 3 minutes. Ice can then be dispensed.

•Remove ice container, thaw, and empty the contents. Clean container, wipe dry, and replace in proper position. When new ice is made, dispenser should operate.

•Ice cubes are jammed between ice maker and back of ice container.

•Ice cubes are frozen together.

•Ice cubes are hollow or smaller than normal.

•Remove ice cubes that are jamming the dispenser.

•Use the dispenser often so that cubes do not freeze together.

•The ice & water filter cartridge could be clogged. Replace the filter cartridge. Dispensing system operates best at 30- 100 psi water pressure. Well water pressures should fall within this range.

Problem Cause

Correction

Dispenser will not dispense water.

•Water supply is not connected.

•Household water line valve is not open.

•Freezer door is not closed.

•Ice & water filter cartridge is clogged.

•Front filter not fully installed, if equipped

•Connect water supply (see page 9).

•Open household water line valve. See Problem section Ice Maker Is Not Making Ice.

•Ensure that freezer door is closed.

•Replace filter cartridge.

•Push filter in until you hear a “click”. Filter should be flush with cabinet.

•Draw and discard 10-12 glasses of water to freshen the supply and completely rinse out the tank.

•Connect unit to cold water line that supplies water to the kitchen faucet.

•For best results, use copper tubing for water connections.

•Contact water treatment plant for help.

•Have someone turn up the cut-off and cut-on pressure on the water pump system (well systems only).

•It is normal for a reverse osmosis system to be below 20 psi during the regenerative phase.