Electro-Voice X-Line Very Compact (XLVC) manual Rigging XLD281 and XS212 Systems Together

Lower the back of the bottom XLD281 enclosure and hold the enclosure at the desired angle. Rotate the rear swing arms back into the rigging channels of the XS212 enclosure above. Install the rear quick-release pins into the rigging channel (in the appropriate hole for the desired angle) and through the hole in the swing arm as shown in Step 3.

ALWAYS MAKE SURE THAT THE QUICK-RELEASE PINS FOR EVERY SWING ARM PASS THROUGH THE HOLE IN THE SWING ARM AND ARE FULLY LOCKED IN THE RIGGING CHANNELS ON ALL ENCLOSURES.

It is possible to rig an XS212 system underneath an XLD281 system. The procedure would be identical to that described above except that the available range to angle the XS212 relative to the XLD281 above is different. In this case the range is -4° to +4°, adjustable in 2° increments. In the - 4° position, the XS212 is aimed 4° down from the XLD281. In the 4° position, the XS212 is aimed 4° up from the XLD281. This configuration is not shown in Figure 7.

Step 2 Step 3

Step 1

Figure 7c:

Rigging XLD281 and XS212 Systems Together

23 ELECTRO-VOICE®X-Line Very CompactTM Rigging Manual