Electro-Voice X-Line Very Compact (XLVC) manual Rigging XLD281 or XLE181 Systems Together

ALWAYS MAKE SURE THAT TWO QUICK-RELEASE PINS SECURE EVERY HINGE BAR AT THE SIDES OF THE ENCLOSURES AND THAT THOSE PINS ARE FULLY LOCKED IN THE RIGGING TUBES ON ALL ENCLOSURES.

There are a series of holes in the rigging channels on the top enclosure. The angle of the bottom enclosure relative to the top enclosure is determined by the hole in which the swing arm from the bottom enclosure is secured. The available angles are 0° to 10°, adjustable in 1° increments, and are noted on the labels on the rigging channel. In the 0° position, the bottom enclosure is aimed at the same angle as the top enclosure. In the 10° position, the bottom enclosure is aimed 10° down from the top enclosure.

Lift the back of the bottom XLD281 enclosure and hold the enclosure at the desired angle. Rotate the rear swing arms up and insert the arms into the rigging channels of the enclosure above. Install the rear quick-release pins into the rigging channel (in the appropriate hole for the desired angle) and through the hole in the swing arm as shown in Step 3.

ALWAYS MAKE SURE THAT THE QUICK-RELEASE PINS FOR EVERY SWING ARM PASS THROUGH THE HOLE IN THE SWING ARM AND ARE FULLY LOCKED IN THE RIGGING CHANNELS ON ALL ENCLOSURES.

Step 2 Step 3

Step 1

Figure 7a:

Rigging XLD281 or XLE181 Systems Together

ELECTRO-VOICE®X-Line Very CompactTM Rigging Manual 20