viking range corporationD3 Downdraft Ventilators
prepare tHe DoWnDraFt
Exterior Blower Installation |
| 10" ROUND |
MOTOR | DISCHARGE | |
| PLUG | PLATE |
The downdraft is shipped without a blower. Purchase a Model | NUTS |
|
|
| |
VEDV900 Exterior Blower and mount the 10" discharge plate |
|
|
to the downdraft as follows: | CLAMP |
|
1. Place the downdraft on its back on a table of flat work surface. |
| |
CHANNELS |
| |
|
|
2.Remove the 4 nuts and 2 clamp channels.
3. | Remove 2 screws and the gear motor cover. | SCREWS |
| |
| COVER | |||
4. | Carefully position the10" discharge plate under the bottom |
| ||
GEARMOTOR | PLATE | |||
| flange of the downdraft. | |||
| COVER |
| ||
|
|
| ||
5. | Connect motor plug. |
| ADDITIONAL | |
6. | Replace the gear motor cover and 2 sheet metal screws. |
| ||
| SCREWS | |||
7. | Replace the 2 clamp channels and start the 4 nuts, do not |
|
| |
| tighten. |
|
| |
8. | Slide blower left of right to desired position. Use cover plate |
|
| |
| (supplied) to close up any open space. |
|
| |
9. | Tighten 4 nuts to secure top of blower. Use additional screws |
| BOTTOM | |
| (supplied) through bottom flange to secure bottom of discharge |
|
plate. | FLANGE |
|
cUt coUntertop opening
All Units
1.Measure and cut the countertop opening for your width of cooktop and downdraft.
Cooktop Width & Model |
| 30" RDECU206 |
| 36" RDECU266 |
| 45" RDECU256 |
|
|
| ||||
| 30" RDGSU200 |
| 36" RDGSU260 |
|
| |
|
|
|
|
| ||
|
|
|
|
|
|
|
For use with Downdraft Models |
| RDIPR101RSS |
| RDIPR161RSS |
| RDIPR151RSS |
|
|
|
|
|
|
|
Cutout Dimensions A |
|
|
| |||
B |
|
|
| |||
C |
| 27" |
| 33" |
| 42" |
D |
|
|
| |||
E |
|
| 15/16" |
| 7/16" | |
F |
|
| 15/16" |
| 7/16" |
EF
C
D
B
BLOWER MODEL | DIMENSIONS |
VIDV500 | 18.25" x 18.214" x 7.569" |
VEDV900 | 28.25" x 24.75" x 7.16" |
VEDV1200 | 22" x 30.828" x 12.724" |
A
6