viking range corporation | D3 Downdraft Ventilators |
|
|
pLan tHe Wiring
Interior Blower Installation
1.The Interior Downdraft Blower system draws 4 AMPS and requires a 120 VAC, 60 Hz circuit.
2.The downdraft has a 2 ft. long power cord with a
iMportant - Location oF eLectricaL oUtLet:
If Model RDIPR101RSS is being installed in a 30" wide
cabinet...
or Model RDIPR161RSS is being installed in a 36" wide
cabinet...
or Model RDIPR151RSS is being installed in a 45" wide
cabinet...
...the outlet cannot be located on the back wall of cabinet.
In these cases, the width of the downdraft covers nearly the entire width of the back wall of the cabinet. So you must either:
•mount the electrical box to a side wall or cabinet floor
- at least 12 inches from the back wall.
•mount the electrical box to a wall stud behind the cabinet - where it will not be covered by the downdraft Then provide a clearance hole in the back wall of the cabinet.
prepare tHe DoWnDraFt
Exterior Blower Installation
1.The Exterior Downdraft Blower system draws 6 AMPS and requires a 120 VAC, 60 Hz circuit.
2.The downdraft has a 2 ft. long power cord with a
iMportant - Location oF eLectricaL oUtLet:
If Model RDIPR101RSS is being installed in a 30" wide
cabinet...
or Model RDIPR161RSS is being installed in a 36" wide
cabinet...
or Model RDIPR151RSS is being installed in a 45" wide
cabinet...
...the outlet cannot be located on the back wall of cabinet.
In these cases, the width of the downdraft covers nearly the entire width of the back wall of the cabinet. So you must either:
•mount the electrical box to a side wall or cabinet floor
- at least 12 inches from the back wall.
•mount the electrical box to a wall stud behind the cabinet - where it will not be covered by the downdraft Then provide a clearance hole in the back wall of the cabinet.
pLeaSenote:External blowers must be
Interior Blower Installation
The downdraft is shipped without a blower. Purchase a Model VIDV500 Interior Blower and mount it to the downdraft as follows:
1.Place the downdraft on its back on a table of flat work surface.
2.Remove the 4 nuts and 2 clamp channels.
3.Remove 2 screws and the gear motor cover.
4.Carefully position the blower under the bottom flange of the downdraft with the 3¼" x 10" discharge pointed in the desired direction.
5.Connect motor plug.
6.Replace the gear motor cover and 2 sheet metal screws.
7.Replace the 2 clamp channels and start the 4 nuts, do not tighten.
8.Slide blower left of right to desired position. Use cover plate (supplied) to close up any open space.
9.Tighten 4 nuts to secure top of blower. Use additional screws (supplied) through bottom flange to secure bottom in blower.
3¼" X 10"
DISCHARGE
NUTS
BLOWER
CLAMP
CHANNELS
SCREWS |
|
|
|
| COVER |
GEARMOTOR | MOTOR | PLATE |
COVER | PLUG |
|
|
| ADDITIONAL |
|
| SCREWS |
| BOTTOM |
5 | FLANGE |
|