Viking F20481 manual Door Reinstallation Bottom-Mount

Page 14

11

Remove screws to remove right and left hinges. Retain

all screws for later use.

Door Reinstallation (Bottom-Mount)

1

2

Install top hinge loosely with 5/16” hex head screws.

Install center hinge with Phillips screws.

3

4

Place hinge side of refrigerator door on center	While holding refrigerator door upright, tighten down
hinge pin.	top hinge with 5/16” hex head drive.

5

6

Replace hinge cover.

Replace toe grille.

26

27

Image 14

Contents Viking Installation Guide Table of Contents Your safety and the safety of others is very important VCBF036 VCFF036 Dimensions Professional Bottom-MountSpecifications Professional Bottom-Mount VCSF036 VCSF036D Dimensions Professional Side-By-SideSpecifications Professional Side-By-Side DDFB036 DDFF036 Dimensions Designer Side-By-Side DDSF036 DDSF036D70-1/2 General Information Before You Throw Away Your Old Refrigerator or FreezerElectrical Requirements Door Removal French Door Bottom-Mount Door and Drawer RemovalDoor Removal Bottom-Mount Remove door closure from center hinge pin on Freezer Drawer Removal Bottom-MountLift right side refrigerator door from center hinge pin From center hinge pinRemove top hinge covers by removing Phillips screws Green ground wire remains attached to the hingeDoor Removal Side-By-Side Door closure from hinge pin on the right side. RetainDoor Reinstallation Bottom-Mount Install top hinge loosely with 5/16 hex head screwsFreezer Drawer Reinstallation Bottom-Mount Door Reinstallation French Door Bottom-MountDoor Reinstallation Side-By-Side Installation Leveling Bottom-Mount & French Door Bottom-Mount Leveling Side-By-SideComplete the Installation Insert filter cartridge into filter housing. Rotate Performance ChecklistWater Filter Installation If Applicable Locate water filter compartment. The compartment isService & Registration