Installation
Connect to Water Supply
Materials Needed
•1/4” outer diameter flexible copper tubing
•
•2 adjustable wrenches
•1/4” hex nut driver
NOTE: Use copper tubing only for installation. Plastic is less durable and can cause damage. Add 8 feet to tubing length needed to reach water supply for creation of service loop.
5 | 6 |
Slide brass nut over sleeve and screw nut into inlet | Using second adjustable wrench, turn the lower nut |
port. Place adjustable wrench on nut attached to plastic | counterclockwise and fully tighten the upper nut in |
waterline and maintain position. | place. IMPORTANT:Do not overtighten. Cross |
| threading may occur. |
1 | 2 | 7 | 8 |
|
|
|
|
| di | a | . | . | |
|
|
|
|
|
| ||||
|
|
| 4 | ” | m | in | |||
| 2 | m | ) |
| |||||
| c |
|
|
| |||||
(6 | 0 | .9 |
|
|
|
|
| ||
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
Create service loop with copper tubing (minimum 2 | Remove plastic cap from water valve inlet port. |
feet diameter). Avoid kinks in the copper tubing when |
|
bending the service loop. Do not use plastic tubing. |
|
3 | Sleeve | 4 |
Brass nut 
1 
2
Pull on tubing to confirm connection is secure. | Turnon water supply.Check for leaks and correctif |
Connect tubing to frame with tubing clamp. | necessary.Monitorwater connectionfor 24 hours. Correct |
| leaks if necessary. |
Place brass nut and sleeve on copper tube end as | Place end of copper tubing into water valve inlet port. |
illustrated. Remember: Do not use old sleeve. The nut | Shape tubing slightly. Do not |
and the sleeve are provided in the consumer literature | feeds straight into inlet port. |
packet. |
|
32 | 33 |