Leveling (Bottom-Mount & French Door Bottom-Mount)
To protect property and refrigerator from damage, observe the following:
•Protect vinyl or other flooring with cardboard, rugs, or other protective material.
•Do not use power tools when performing leveling procedure.
Materials Needed
•3/8” hex head driver
•1/4” hex head driver
•Carpenter’s level
To enhance the appearance and maintain performance, the refrigerator should be level.
NOTE: Complete any required panel installation and/or water supply connection before leveling. Refrigerator should be in permanent location prior to leveling.
1 | A |
2 |
Leveling (Side-By-Side)
To protect property and refrigerator from damage, observe the following:
•Protect vinyl or other flooring with cardboard, rugs, or other protective material.
•Do not use power tools when performing leveling procedure.
Materials Needed
•3/8” hex head driver
•Carpenter’s
•Stabalizing legs are stored in the freezer basket. Install Stabalizing legs by tipping refigerator back slightly and screwing the legs in clockwise.
NOTE: Complete any required panel installation and/or water supply connection before leveling. Refrigerator should be in permanent location prior to leveling.
1 | 2 |
Remove toe grill. Grasp firmly and pull outward
to unclip.
A
3 
To raise the front of the unit, turn the leveler foot screw clockwise. To raise the rear of the unit, use a 3/8” hex head driver to turn each of the adjustmentscrews (A) clockwise (French Door models only).
NOTE: Having someone push against the top of the refrigerator
takes some weight off the leveler foot screws.
4
| A | A |
Remove toe grille. | Using hex head driver, turn the front adjustment screws | |
Grasp firmly and pull outward to unclip. | “A” on each side to raise or lower the front of the | |
|
| refrigerator. |
34
B | B |
To lower the front of the unit, turn the leveler foot screw | Replace toe grill. Align the toe grille mounting clips |
counterclockwise. To lower the rear of the unit, use a 3/8” | with the lower cabinet slots. Push the toe grille firmly |
hex head driver to turn each of the adjustmentscrews (A) | until it snaps into place. Check for level. |
counterclockwise(French Door models only). |
|
NOTE: It may take several turns of the leveler foot screw to
adjust the tilt of the refrigerator.
Using the hex head driver, turn each of the adjustment | Using the carpenter’s level, make sure front of |
screws “B” to raise or lower the rear of the refrigerator. | refrigerator is 1/4” (.06 cm) or approximately half a |
| bubble higher than back of refrigerator. |
34 | 35 |