Installation, Tip Over Hazard, Unpacking unit

General Information

Installation

•Most of the unit’s weight is at the top. Extra care is needed when moving the unit to prevent tipping.

•Do Not remove protective film until unit is in operating position.

•All four leveling legs must contact the floor to support and stabilize the full weight.

•Do not drop unit.

•Remove exterior shipping materials prior to moving unit into home.

•Use two or more people to move and install unit. Failure to follow this instruction can result in back or other injury.

•To avoid personal injury, wear gloves when performing any installation procedure and wear eye protection when cutting metal straps.

TIP OVER HAZARD

Appliance is top heavy and tips easily when not completely installed. Keep doors closed until appliance is completely installed and secured per installation instructions. Use two or more people to move and install appliance. Failure to do so can result in death or serious injury.

Unpacking unit

1.Remove top and bottom strap.

2.Remove top cap.

3.Cut carton rear approximately 1/4”

(0.6 cm) to 1” (2.5 cm) from right corner with a utility knife extended 1/4” (0.6 cm).

4.Remove carton and exterior packaging. Save cardboard shipping material to protect floor surface when installing unit. Remove anti-tip board, kickplate and door trim pieces (DF models) from rear of unit.

Place unit in front of cutout.

(Professional) Lift center grille louver up

and pull out.

Moving Unit

Remove shipping brackets from skid by removing 4 bolts

Slip appliance dolly between unit and skid. Remove

(2 on each side) with a 1/2” deep-well socket wench and

unit from skid.

a pair of pliers.

Note: Use excess packaging to protect decorative trim;

Note: Tilting unit is not required to remove

also, verify that leveling legs are up (0” adjustment).

shipping brackets.

(Designer) Pull the center grille louver up

at an angle and pull out.

Remove grille assembly.

Using an 8” magnetic nut driver, remove

the two 1/4” screws.