Breville BES920XL manual Begin Descale, Empty Descale Solution, Fill Boilers, Flush Boilers

Page 19

CARE & CLEANING

e)Close both valves by rotating screws clock-wise until seated. Do not overtighten screws to avoid damaging the valves.

f)Empty drip tray and reinsert into position. Use caution as the drip tray may be hot due to the water and steam from the boilers.

g)Empty water tank, remove water filter.

h)Empty descale solution into water tank, then top with cold water to MAX line, or as per manufacturer’s instructions. Replace and lock water tank back into position at the back of the machine.

i)Press MANUAL button to proceed to the next step.

NOTE

If boilers are not empty, the machine will beep 3 times and ‘vALv’ will be displayed on the LCD.

Step 3 – Begin Descale

a)20 minute timer will begin. Machine will fill boilers with descale solution and heat to temperature. During this time, water may flow through the group head. Wait for countdown timer to finish. This allows solution to dissolve scale build up.

b)The LCD will display ‘PUSH’ when the timer has finished.

Step 4 – Empty Descale Solution

a)Empty water tank then rinse and fill with clean water to the MAX line. Replace and lock water tank back into position at the back of the machine.

NOTE

If water tank has not been removed then replaced or is empty, water tank LED will flash 5 times, the machine will beep 3 times and ‘FILL TANK’ will be displayed on the LCD.

b)Place a cloth over the drip tray to stop steam escaping.

c)Use a flat-head screwdriver to rotate the right screw counter-clockwise until the valve is fully open. As the valve opens, steam may be released.

CAUTION

HOT WATER & STEAM

CARE & CLEANING

d)Next, repeat the process on the left screw. As the valve is opened, water may begin flowing into the drip tray.

e)Allow valves to remain open until no more water or steam escapes.

f)Close both valves by rotating screws clock-wise until seated. Do not overtighten screws to avoid damaging the valves.

g)Empty drip tray and reinsert into position. Use caution as the drip tray may be hot due to the water and steam from the boilers.

h)Press MANUAL button to proceed to next step.

Step 5 – Fill Boilers

a)5 minute timer will begin. During this time, water may flow through the group head. Wait for countdown timer to finish. This allows any remaining solution to be removed from the system.

b)The LCD will display ‘PUSH’ when the timer has finished.

Step 6 – Flush Boilers

a)Empty and rinse water tank. Assemble new water filter into tank.

b)Fill water tank with cold water to MAX line. Replace and lock water tank back into position at the back of the machine.

c)Ensure drip tray is empty and fully inserted into position.

d)Place a cloth over the drip tray to stop steam escaping.

e)Use a flat-head screwdriver to rotate the right screw counter-clockwise until the valve is fully open. As the valve opens, steam may be released.

CAUTION

HOT WATER & STEAM

f)Next, repeat the process on the left screw. As the valve is opened, water may begin flowing into the drip tray.

g)Allow valves to remain open until no more water or steam escapes.

h)Close both valves by rotating screws clock-wise until seated. Do not overtighten screws to avoid damaging the valves. Replace the grey silicone cover over the valves.

i)Empty drip tray and reinsert into position. Use caution as the drip tray may be hot due to the water and steam from the boilers.

j)Press MANUAL button to complete descale procedure. Machine will heat up and is ready to use once operating temperature (STANDBY mode)

is reached.

36

 

37

 

 

 

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Suits all BES920XL models MailPhone WebCongratulations ContentsPAgeBrevilleheadrecommendsr..... safety first Important safeguardsBreville Assist Plug KnowTriple Heat System Additional featuresPrecision control Operating AccessoriesFirst USE Installing the Water FilterSetting Water Hardness Before First USECUP Button Power Save ModeLCD Interface General OperationManual Button SteamHot Water Programmable FunctionsExtraction temperature Set Clock Reprogramming Shot VolumeReprogramming Shot Duration Auto Start Cleaning CycleAdvanced Features Reset Default Settings rSEtAlerts Pre-Infusion ProgrammingTransporting and storing Coffee Making Tips Preparation Coffee Making Tips & Preparation Hints & Tips Inserting the PortafilterExtracting Espresso Texturing MilkCare & Cleaning Care & CleaningInstalling Water Filters Cleaning the Outer Housing & CUP Warming Tray Cleaning the Steam WandCleaning the Drip Tray & Storage Tray Cleaning the Shower ScreenFlush Boilers Empty Descale SolutionBegin Descale Fill BoilersUsing the Allen KEY TroubleshootingPossible Causes What to do PAgeTROUBLESHOOTINGheaderAnd/or E1, E2 or E3 errorEspresso runs out too QuicklyTroubleshooting Espresso Coffees to TRYCoffees to TRY CappuccinoTable des matières FélicitationsImportantes Mesures DE Sécurité Breville Vous Recommande LA Sécurité Avant ToutCourt Cordon ’ALIMENTATION Faites LA ConnaissanceContrôle DE Précision Triple Système DE ChauffageCaractéristiques Additionnelles Fonctionnement AccessoiresPremière Utilisation Installation DU Filtre À EAUFonctionnement DE Votre Produit Breville Avant LA Première UtilisationTouche 1 Tasse Mode D’ÉCONOMIE D’ÉNERGIEÉcran ACL Fonctionnement GénéralTouche Manuelle VapeurEAU Chaude Touche 2 TassesTempérature D’EXTRACTION Reprogrammer LE Volume DE L’ESPRESSOFonctions Programmables Reprogrammer LA Durée DE L’ESPRESSOCycle DE Nettoyage Régler L’HEUREDémarrage Automatique Fonctions AvancéesSon de la machine Snd PAgeFONCTIONNEMENTheader..... DE Votre Produit BrevilleRéinitialiser les réglages par défaut rSEt Température de la vapeur StEAAlertes Programmer LA PréinfusionÉtape 2 Vider les chaudières Transport ET EntreposageÉtape 1 Préparation LA Mouture Trucs ET Préparation DU CaféPréchauffage Choisir LES Paniers FiltresMousser LE Lait Dosage ET TassageInsérer LE PORTE-FILTRE Extraire L’ESPRESSOTrucs & Astuces PAgeTRUCSheaderET PRÉPARATION..... DU CaféGuide D’EXTRACTION Rincer À L’EAU Claire Installer LE Filtre À EAUNettoyer LA Buse Vapeur Nettoyer LES Paniers Filtres ET LE PORTE-FILTREÉtape 3 Débuter le détartrage Détartrage dEScÉtape 5 Remplir les chaudières Utiliser LA CLÉ AllenÉtape 6 Purger les chaudières PAgeGUIDEheaderDE Dépannage Guide DE DépannageProblème Causes Possibles QUE FAIRE? Fonctionner Pas de vapeurLa machine est en Marche, mais cesse de’espresso déborde Le café n’est pas assezChaud Pas de cremaACL Guide DE DépannageSuggestions DE Café Suggestions DE CaféAmericano

the Dual Boiler, BES920XL specifications

The Breville BES920XL Dual Boiler Espresso Machine is a sophisticated piece of kitchen equipment designed for coffee enthusiasts who demand precision and quality in their brewing process. This machine stands out due to its advanced dual boiler system, allowing users to extract espresso and steam milk simultaneously. This feature significantly reduces wait times, enabling a quicker workflow in busy morning routines or when entertaining guests.

One of the standout characteristics of the Breville BES920XL is its digital temperature control (PID) technology. This innovative feature ensures that the water temperature remains consistent for each shot, providing optimal extraction conditions. Consistency in temperature is crucial for achieving the rich flavors and nuanced profiles that high-quality coffee beans possess.

The BES920XL also comes equipped with a shot clock and pre-infusion functionality. The shot clock helps users keep track of extraction times, ensuring that each shot is pulled to perfection. The pre-infusion feature gradually increases the pressure during the brewing process, allowing the coffee grounds to expand and bloom, which enhances flavor extraction.

Additionally, the machine features a stainless steel construction that not only provides durability but also gives it a professional look fitting for a high-end kitchen. The large water tank, capable of holding 84 ounces, means fewer trips to refill and the convenience of brewing multiple drinks in a row.

Another attractive aspect of the Breville BES920XL is its steam wand, featuring a commercial-style design. This steam wand allows for precise milk texturing and microfoam creation, essential for crafting lattes, cappuccinos, or flat whites. The easy-to-use control dials simplify the processes of adjusting steam pressure and temperature, making it accessible even for those new to espresso making.

In terms of user-friendly features, the BES920XL includes a clear LCD screen displaying important information, such as water temperature and brew time. The intuitive interface helps users navigate through different settings with ease.

Finally, the machine also comes with a range of accessories, including a portafilter, cleaning tools, and a stainless steel milk jug, providing everything needed to start making cafe-quality beverages at home. The Breville BES920XL Dual Boiler Espresso Machine is a perfect investment for those who appreciate the artistry of espresso and desire a high level of control over their brewing process.
Top Page Image Contents