Breville BKC600XL/BKC700XL manual LCD screen will indicate the default brew size 7.25 oz.. To

Operating your breville gourmet single cup brewer™

Operating your breville gourmet single cup brewer™

NOTE:

There are two sharp needles used to puncture the K-Cup®and My K-Cup®Holder. One in the base of the K-Cup®Holder, the other on the underside of the Brewing Chamber Head. To avoid risk of injury, use caution when inserting or removing the K-Cup®, K-Cup®Holder or My K-Cup®Holder.

11.Lower the Safety Locking Arm to close the Brewing Chamber Head over the My K-Cup®Holder. When closed completely, the LCD screen will indicate

‘READY TO BREW’. The and buttons will illuminate and the ‘BREW’ button will illuminate and flash for up to 60 seconds.

a)The LCD screen will indicate the default brew size (7.25 oz.). To

choose a different size, press the

to go up in size or the button to go down in size.

NOTE:

Select from a stronger small cup (5.25 oz. serving), a small mug (7.25 oz. serving), a large mug (9.25 oz. serving), a travel mug (11.25 oz. serving) or iced beverage setting (3.25oz serving). The iced beverage setting is only available on the the BKC700XL.

The small mug (7.25 oz. serving) is the default brew size.

To program your favorite brew size, refer to Setting the ‘BREW SIZE’ feature (page 24).

NOTE:

To use the iced beverage setting, place a tall glass filled with ice on the drip tray. Use your favorite K-Cup®, select the iced beverage brew size button. Add more ice once brewing is complete, add cream and sugar if desired. The iced beverage setting is only available on the BKC700XL.

b)Once the brew size is selected, press the ‘BREW’ Button. The ‘BREW’ button will stop flashing,

the and buttons will no longer be lit. The LCD screen will indicate ‘BREWING’ and the selected brew size.

NOTE:

If the ‘BREW’ button is not pressed in 60 seconds, the LCD screen will indicate ‘OPEN HEAD’ and the ‘BREW’ button will be disabled to prevent accidental activation. To re-activate the brew sequence, open the Brewing Chamber Head by raising and lowering the Safety Locking Arm completely.

12.The LCD screen will indicate ‘BREWING’, however there may be a short pause before the brewing process begins. The process lasts about 60 seconds and ends with a burst of air to remove all liquid from the My K-Cup®Holder.

NOTE:

There is extremely hot water in the My K-Cup®Holder during the brewing process. To avoid risk of injury, do not raise the Safety Locking Arm or open the Brewing Chamber during the brewing process.

Following the brew, the LCD screen will indicate ‘HEATING’ as the Brewer heats the water for the next brew cycle. This process lasts about 15 seconds. The pump will make a vibrating sound. This is normal.

13.Raise the Safety Locking Arm, remove the assembled My K-Cup®Holder. Use caution as the My K-Cup®Holder will be hot.

14.Disassemble the My K-Cup®Holder by removing the Lid from the Holder in a counter-clockwise direction. Remove the Filter Basket from the Holder, discard the grounds and rinse out the Filter Basket and Holder.

15.15. Enjoy your first cup of gourmet coffee, tea or hot cocoa!

16 17