KitchenAid KBFS20ETBL installation instructions Refrigerator Doors and Drawer

Page 6

Refrigerator Door(s) and Drawer

Graphics are included later in this section.

Remove and Replace Handles

1.Using a ³⁄₃₂" Allen wrench, loosen the two set screws located on the side of each handle. See Graphics 1 and 2.

2.Pull the handle straight out from the door. Make sure you keep the screws for reattaching the handles.

3.To replace the handles, reverse the directions.

Remove Doors and Hinges

WARNING

Electrical Shock Hazard

Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

IMPORTANT:

■Remove food and any adjustable door or utility bins from doors.

■All graphics referenced in the following instructions are included later in this section after “Final Steps.”

TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex-head socket wrench, #2 Phillips screwdriver, and a flat-blade screwdriver.

1.Unplug refrigerator or disconnect power.

2.Keep the refrigerator doors closed until you are ready to lift them free from the cabinet.

NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.

3.Starting with the right-hand side door, remove the parts for the top hinge as shown in Top Hinge graphic. Lift the refrigerator door from the bottom hinge pin.

NOTE: On some models, remove the shim from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic.

4.Before removing the left-hand side door, disconnect the wiring plug located on top of the top hinge by wedging a flat-blade screwdriver or your fingernail between the two sections. See Wiring Plug graphic.

NOTE: The green, ground wire remains attached to the hinge.

5.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the left-hand side door from the bottom hinge pin.

NOTE: On some models, remove the shim from the bottom hinge pin and keep it for later use. See Bottom Hinge graphic.

Replace Doors and Hinges

1.Assemble the parts for the top hinge as shown in Top Hinge graphic. Do not tighten the screws completely.

2.Replace the parts for the bottom hinge as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator door.

NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.

3.Align the door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws.

4.Reconnect the wiring plug on top of the left-hand side refrigerator door.

5.Replace the top hinge covers.

Remove and Replace Freezer Drawer

IMPORTANT: Two people may be required to remove and replace the freezer drawer. Graphics are included later in this section.

Remove Drawer Front

1.Open the freezer drawer to full extension.

2.Loosen the four screws attaching the drawer glides to the drawer front. See Drawer Front Removal graphic.

NOTE: Loosen screws three to four turns. Keep the screws in the drawer front.

3.Lift drawer front upward and off the screws. See Drawer Front Removal graphic.

Replace Drawer Front

1.Slide the drawer glides out of the freezer compartment. Insert the screws in the top of the drawer front into the slots in the drawer brackets. See Drawer Front Replacement graphic.

2.Pull the drawer brackets toward you to position the two screws in the bottom of the drawer front into the brackets. See Drawer Front Replacement graphic.

3.Completely tighten the four screws.

4.Replace the base grille.

Final Steps

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Plug in refrigerator to a grounded 3 prong outlet.

2.Return all removable door parts to doors and food to refrigerator.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Refrigerator Safety Refrigerator User InstructionsUnpack the Refrigerator Installation InstructionsClean Before Using Before You Throw Away Your Old Refrigerator or FreezerWater Supply Requirements Location RequirementsElectrical Requirements Recommended Grounding MethodConnect the Water Supply Complete the Installation Refrigerator Doors and Drawer Door Removal & Replacement Temperature Controls Adjust the DoorUsing the Controls Refrigerator USEAdditional Control Center Features Max Cool Adjusting ControlsTo Adjust Set Point Temperatures OptimIce FeatureCrisper Humidity Control Ice MakerWater Dispenser Cleaning Refrigerator CareWater Filtration System Troubleshooting Changing the Light BulbRefrigerator Operation Temperature and Moisture Ice and WaterWater is leaking from the dispenser system Water Filter CertificationsWater dispenser will not operate properly Water from the dispenser is warmProduct Data Sheets Application Guidelines/Water Supply ParametersItems Kitchenaid will not PAY for Kitchenaid Refrigerator WarrantyONE Year Limited Warranty Disclaimer of Implied Warranties Limitation of RemediesPage Instructions Dutilisation DU Réfrigérateur Sécurité DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Instructions D’INSTALLATIONDéballage du réfrigérateur Enlèvement des matériaux d’emballageSpécifications électriques Exigences demplacementMéthode recommandée de mise à la terre Spécifications de l’alimentation en eauAlimentation en eau par osmose inverse Raccordement de la canalisation deauPression de leau Raccordement à une canalisation d’eauAchever l’installation Enlèvement et réinstallation des poignéesPortes et tiroir du réfrigérateur Enlèvement de la porte et des charnières Remplacement de les portes et des charnièresRéinstallation de la façade du tiroir Tiroir de congélationDémontage et réinstallation de la porte Ouverture et fermeture des portes Utilisation DU RéfrigérateurAjustement de la porte Style 1-Nivellement avant et arrièreUtilisation des commandes Temp Alarm alarme de dépassement de température Holiday Mode mode vacancesDoor Alarm avertisseur de la porte Alarme ALRéglage de lhumidité dans le bac à légumes Machine à glaçonsDistributeur d’eau Entretien DU Réfrigérateur Système de filtration de leauNettoyage Remplacement de l’ampoule d’éclairage Remplacement de lampoule du compartiment de réfrigérationRemplacement de lampoule du compartiment de congélation Dépannage Fonctionnement du réfrigérateurTempérature et humidité Glaçons et eau’eau coule du système de distribution Goût, odeur ou couleur grise des glaçonsLe distributeur deau ne fonctionne pas correctement Leau du distributeur est tièdeFeuilles DE Données SUR LE Produit Système de filtration d’eau intérieurGarantie DU Réfrigérateur Kitchenaid Garantie Limitée DE UN ANKitchenaid NE Prendra PAS EN Charge W10137643A SP PN W10137644A All rights reserved

KBFS20ETBL specifications

The KitchenAid KBFS20ETBL is a refrigerator that combines sleek design with advanced technology to create a practical and stylish addition to any kitchen. One of its standout features is the French door configuration, which not only enhances its aesthetic appeal but also optimizes storage space. The refrigerator’s split shelves and organized compartments make it easier to access all your favorite foods and beverages.

At the heart of the KBFS20ETBL is a powerful and efficient cooling system that is designed to maintain optimum temperatures throughout the fridge and freezer compartments. The Fresh Storage technology ensures your fruits and vegetables stay fresher for longer, significantly reducing waste. With humidity-controlled crispers, you can store produce without worrying about moisture loss or spoilage.

Another major feature is the ExtendFetch drawer, which allows users to slide out the drawer fully, making access to items at the back easier than ever. This feature reduces the need to reach or bend, improving convenience and accessibility. Additionally, the refrigerator includes an ice and water dispenser located on the external door, providing chilled water and ice without the need to open the fridge, which helps maintain internal temperatures.

The KBFS20ETBL is also fitted with the In-Door-Ice System, which maximizes space in the freezer section by freeing up shelf space while still providing a generous supply of ice. This innovative technology allows for more room to store frozen goods without sacrificing ice production.

Energy efficiency is another hallmark of the KitchenAid KBFS20ETBL, as it meets stringent ENERGY STAR guidelines. Users can feel good knowing that they are not only benefiting from exceptional performance but are also reducing their carbon footprint.

The elegant black finish adds a contemporary touch, while the stainless steel handles offer durability and style. Inside, LED lighting illuminates every corner of the fridge, making it easy to find what you need, even in low light.

In summary, the KitchenAid KBFS20ETBL stands out with its combination of smart design, advanced food preservation technologies, and energy efficiency, making it a highly functional and stylish choice for modern kitchens. Whether you’re storing leftovers, perishable groceries, or beverages, this refrigerator meets the demands of today’s households with ease and sophistication.
Top Page Image Contents