KitchenAid W10190011A, W10189714A installation instructions Complete Installation, Abc

Page 10

For Roof Venting Installation Only

1.Insert damper assembly through the cabinet cutout so that the long tab of the damper assembly slides into the slot on the left side of the damper vent opening, as shown. Then secure with mounting screw.

NOTE: The screw cannot be installed if the damper assembly is not positioned as shown.

ABC

D

A. Long tab (inside slot)

B. Damper assembly

C. Mounting screw

D. Upper cabinet cutout

2.Connect vent to damper assembly.

A B

A.Vent

B.Damper assembly (under vent)

Complete Installation

1.Refer to the Use and Care Guide for instructions on how to install filters into your model.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

2.Plug microwave oven into grounded 3 prong outlet.

3.Reconnect power.

4.Check the operation of microwave oven by placing 1 cup

(250 mL) of water on the turntable, and programming a cook time of 1 minute at 100% power. Test vent fan and exhaust by operating the vent fan.

5.If the microwave oven does not operate:

Check that a household fuse has not blown, or that a circuit breaker has not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Check that the power supply cord is plugged into a grounded 3 prong outlet.

See the Use and Care Guide for troubleshooting information.

Installation is now complete.

Save Installation Instructions for future use.

10

Image 10
Contents Microwave Hood Combination Installation Instructions Microwave Hood Combination SafetyTools and Parts Installation RequirementsLocation Requirements Electrical Requirements Product DimensionsInstallation Dimensions RequiredRemove Mounting Plate Installation InstructionsTo Install Vent Deflector Convert Microwave Oven to External VentingC D Possible Wall Stud Configurations Locate Wall StudsMark Rear Wall Drill Holes in Rear WallNo Wall Studs at Corner Holes Figures 1 Attach Mounting Plate to WallPrepare Upper Cabinet Wall Stud at One Corner Hole FigureInstall the Microwave Oven For Roof Venting Installation OnlyComplete Installation Rectangular to Round Transition Venting Design SpecificationsFor optimal venting installation, we recommend Recommended Standard FittingsRecommended Vent Length Replacement PartsAssistance ¹⁄₄ x 10 8.3 x 25.4 cm vent system = 73 ft 22.2 m total