KitchenAid W10189714A Product Dimensions, Electrical Requirements, Installation Dimensions

Page 3

Installation Dimensions

NOTE: The grounded 3 prong outlet must be inside the upper cabinet. See “Electrical Requirements” section.

AB

 

30"

 

(76.2 cm)

33"

min.

 

(83.2 cm)

 

typical*

12" (30.5 cm) min.

 

 

13" (33.0 cm) max.

69" (175.3 cm) min.

 

A. 2" x 4" wall stud

B. Grounded 3 prong outlet

*33" (83.2 cm) is typical for 69" (175.3 cm) installation height. Exact dimension may vary depending on type of range/cooktop below.

Product Dimensions

18¹⁄₄" (46.4 cm) 29⁷⁄₈" (76.0 cm)

15¹⁄₂" (39.4 cm)

18¹⁄₄" (46.4 cm)

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Observe all governing codes and ordinances.

Required:

A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker.

Recommended:

A time-delay fuse or time-delay circuit breaker.

A separate circuit serving only this microwave oven.

GROUNDING INSTRUCTIONS

For all cord connected appliances:

The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.

WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.

SAVE THESE INSTRUCTIONS

3

Image 3
Contents Microwave Hood Combination Safety Microwave Hood Combination Installation InstructionsInstallation Requirements Tools and PartsLocation Requirements Required Product DimensionsInstallation Dimensions Electrical RequirementsConvert Microwave Oven to External Venting Installation InstructionsTo Install Vent Deflector Remove Mounting PlateC D Locate Wall Studs Possible Wall Stud ConfigurationsDrill Holes in Rear Wall Mark Rear WallWall Stud at One Corner Hole Figure Attach Mounting Plate to WallPrepare Upper Cabinet No Wall Studs at Corner Holes Figures 1For Roof Venting Installation Only Install the Microwave OvenComplete Installation Recommended Standard Fittings Venting Design SpecificationsFor optimal venting installation, we recommend Rectangular to Round Transition¹⁄₄ x 10 8.3 x 25.4 cm vent system = 73 ft 22.2 m total Replacement PartsAssistance Recommended Vent Length