3.When the vent deflector is as far back as it can easily slide, flip it so that the wide side is to the back of the microwave oven, and the narrow side (with holes) is down. The vent deflector holes should align with mounting holes in the vent opening, as shown in inset.
A B
A. Vent opening
B. Vent deflector
4.Secure vent deflector with 2 mounting screws (1 on each end).
A B
A. Mounting screw
B. Vent deflector
5.Replace vent screen.
Wall Venting Installation Only
To Remove Wall Damper Vent Cover:
1.Locate the wall damper vent cover on the back of the microwave oven.
2.Using diagonal wire cutting pliers, gently snip out the damper vent cover at the perforations.
A B C D
A. Diagonal wire cutting pliers
B. Back of microwave oven
C. Wall damper vent cover
D. Perforations
3.Save the cover for possible change of venting method in the future.
4.Position the damper assembly so that the long tab slides into the slot on the right side of the damper vent opening, as shown. Then secure with mounting screw.
A BC
A. Mounting screw
B. Damper assembly
C. Long tab (inside slot)
Roof Venting Installation Only
To Remove Roof Damper Vent Cover:
1.Locate the roof damper vent cover on the top of the microwave oven.
2.Using diagonal wire cutting pliers, gently snip out the damper vent cover at the perforations.
AB C
D
A. Diagonal wire cutting pliers
B. Top of microwave oven
C. Roof damper vent cover
D.Perforations
3.Save the cover for possible change of venting method in the future.
NOTE: Do not install damper assembly at this time.
5