Kambrook KFP95 manual Blade Operating Guide, Stainless Steel Processing Blade

Blade Operating Guide

The Stainless Steel Processing Blade

The cutting edge of this blade is extremely sharp, it should only ever be held by the central plastic spindle.

ALWAYS store the blade with the protective cover provided.

Chopping	Use Processing Blade
Ingredients	Procedure
Onions, Vegetables, Fruits	Cut ingredients into approximately 2.5cm cubes.
and Cooked Meats	Place in processing bowl, up to 750g at a time.
	Process, using the PULSE switch until the ingredients
	are chopped as desired. Remove lid and scrape
	the sides down with the spatula between pulses to
	ensure more even chopping.
Raw Meats (Boneless)	Trim the meat of fat and gristle, remove any bones.
	Cut into 2.5cm cubes. Process up to 750g at a time
	on MED or MAX speed, scraping down the sides of
	the bowl, until the meat is coarse or fine as desired.
Herbs	Make sure the herbs are as dry as possible. Place
	in the processing bowl and process on MED or
	MAX speed, until finely chopped. Scrape down the
	sides of the bowl at least once during processing.
	Up to 4 cups of firmly packed herbs can be
	processed at a time.
Breadcrumbs or	Quarter the slices of bread and break up the
Biscuit	biscuits. Place them in the processing bowl and
	process using MED speed. Process up to 1½ loaves
	of bread, crusts removed, or 1 loaf with crusts, at a
	time. Use stale bread for dry breadcrumbs.
Nuts (Shells Removed)	Place up to 2 cups of nuts in the processing bowl
	at a time and process using the PULSE switch.
	If chopped too finely the nuts will become oily
	and eventually form a butter. Processing smaller
	quantities at one time will ensure even chopping.
Hard Cheeses	To process hard cheese such as Parmesan, first cut
	the cheese into 2cm cubes. Turn speed to LOW,
	and drop cubes of cheese down the feed tube,
	processing 200g at a time.
Hard Boiled Eggs	Shell and halve the eggs before placing in the
	processing bowl. Process using the PULSE switch.

NOTE: When mixing liquids with the processing blade, do not fill above the bowls 750ml fill line. Do not use the MAX speed as liquids will spill over the bowl.

14