Preparing the Location | KitchenAid KUD-22 instruction

2 PREPARING THE LOCATION

Access holes in the cabmets, floor, or rear wall for the hot water supply line, drain line, and electrical supply must be located within the shaded area in Fig. 3 in order to avoid Interference with the dishwasher frame or other components.

HOT WATER	SUPPLY	LINE	Fig.	3
PLUMBING CONNECTIONS MUST COMPLY WITH APPLICABLE SANITARY, SAFETY, AND PLUMBING
CODES.				I
				I
Water supply	should	be 120°F (49OC) minimum	at the	dishwasher. (Refer to Use & Care Guide.)

The hot water supply line should be 5%” (16 mm) OD copper tubing or l/2” (13 mm) galvanized pipe. The dishwasher fill valve has a l/z” (13 mm) NPT female connection.

Atter determining where the water supply line will enter the dishwasher opening, drill a 1” (25 mm) access hole and run the line to the approximate fill valve location as shown in Fig. 4.

4” (102 mm)

-(Frbm floor)

6” (152 mm)

Fig. 4

For service convenience, a shut-off valve (not supplied) should be installed in the supply line in a readily accessible location (such as beneath the sink) and a union (not supplied) should be installed in the supply line near the dishwasher fill valve.