Dual Valve TripleTier™ Flame Burner
1
2 | 5 |
| |
3 |
|
4 |
|
1.Dual Valve TripleTier™ Flame Burner Caps
2.Burner base
3.Alignment pins
4.Igniter
5.Gas tube opening
Gas tube opening
Gas must flow freely throughout the gas tube opening for the burner to light properly. Keep this area free of soil and do not allow spills, food, cleaning agents or any other material to enter the gas tube opening. Protect it from spill overs by always using a burner cap.
Standard Burner
1
2
1.
2.Burner ports
TripleTier™ Flame Burner
1 | 2 | 2 |
3
1.³⁄₄ in. (19.1 mm)
2.³⁄₈ in. (9.53 mm)
3.Burner ports
Burner ports
Check burner flames occasionally for proper size and shape as shown above. A good flame is blue in color, not yellow. Keep this area free of soil and do not allow spills, food, cleaning agents or any other material to enter the burner ports.
To Clean:
1.Remove the burner cap from the burner base and clean according to “General Cleaning” section.
2.Clean the gas tube opening with a damp cloth.
3.Clean clogged burner ports with a straight pin as shown. Do not enlarge or distort the port. Do not use a wooden toothpick. If the burner needs to be adjusted, contact a trained repair specialist.
4.Replace the burner cap, making sure the alignment pins on the cap are properly aligned with the burner base.
1
2
1.Incorrect
2.Correct
5.Turn on the burner. If the burner does not light, check cap alignment. If the burner still does not light, do not service the sealed burner yourself. Contact a trained repair specialist.
7