Setting Up Your Food Processor
Installing the Egg Whip
IMPORTANT: The egg whip can only be used with the work bowl.
1.Be sure the egg whip is properly assembled. If the two pieces have been disassembled for cleaning, align the pin on the egg whip adapter with the slot on the egg whip, and rotate to lock into place.
2.With the work bowl in place on the base, place the egg whip on the power shaft.
3.Rotate the egg whip so it falls into place on the power shaft.
4.Install the work bowl cover, being sure it locks into place.
Using the 3-in-1 Feed Tube
The 3-in-1 feed tube
features a
entire food pusher to process large items, or use the inner portions to
create
to process smaller items.
To slice or shred small items, insert the
pusher into the feed tube, then lift out the small pusher to
remove. Use the small feed tube and
pusher to process
small or slender items, like single carrots or celery stalks. When not using the small feed tube, be sure to lock the small pusher into place.
To slowly drizzle oil or other liquid ingredients into the work bowl, just fill the small pusher with the desired amount of liquid. A small hole in the bottom of the pusher will drizzle the liquid ingredient at a constant rate.
16