Siemens 5551 manual Requirements for the cabinet, Appliance installation

IMPORTANT INFORMATION
Requirements for the cabinet			3 - Depending on the model, the clips and the
Fig. 1a
			watertight seal (lower edge of the cooktop)
			may already be fitted; if this is the case, do not
			remove them under any circumstance.
			The seal ensures that the entire work surface
	E		will be watertight, and prevents water seepage.
			If this item has not been fitted in the factory,
			remove the pan supports and the gas burner
	C	F	covers and diffusers from your cooking hob,
			and turn it upside down.Now fit the adhesive seal
		B	supplied with the appliance onto the lower edge
D			of the cooking hob,Fig. 2a,remove the clips from
			the attached accessories bag and screw them
A			into the lower points designed for this purpose,
			Fig. 2 b. Place the cooktop in the middle of the
			opening where it is to be inserted into the
			kitchen unit.
			Once the hob is fitted you should turn the clip
			and tighten the screw as shown in Fig. 2b. For
			disassembly, unscrew the clip and proceed in
			the reverse manner.
			Note: do not stick the hob onto the worktop
A- Minimum 6” (152 mm)	D- Minimum 2” (51 mm)		with silicone.
B- Minimum 6” (152 mm)	E- Minimum 36” (915 mm)		If the oven is not installed under the cooktop,
C- Minimum 30” (762 mm)	F- Minimum 18” (458 mm)		place a separator of non-flammable material to
			prevent access to the lower part of the cooktop.
Maximum depth of cabinets installed above
			To install the cooktop over an oven, check the
cooktop: 13" (330 mm.)
			dimensions given in the installation manual.

Appliance installation		Figure. 2a
	min. 71/4”
min. 213/16”
191/4”	331/2”
Fig. 1b		Figure. 2b
331/2”
	13/4”
	11/16”	Figure. 2c
		191/4”
	11/16”
18