Fig W

Screw in the new main burner tip, pushing the					Unscrew the burner tip Fig. M4 from component
burner tip casing in the opposite direction with a					Fig. M2 and replace it with the appropriate burner
13 mm spanner.					tip as indicated in the burner tip table, and adjust
Loosen the holding screw Fig. L1 and set the					the regulating bushing of the air flow M5 in line with
regulating bushing of the air flow to the value					the value indicated in the burner tip table. -Y-
indicated in the burner tip table.-Z-					* If the appliance is not firmly fixed or the clipping
Tighten the locking screw.					system is too rigid, it may cause the entire appliance
7 - Changing the inner flame burner tip. Fig. M.					to lift up. In this case follow this procedure:
Using an 8 mm spanner, unscrew the connector					1) Loosen the fixing clips of the appliance to
Fig. M3 from the threaded component Fig. M2. To					the kitchen unit.
do this, hold the threaded component firmly in the					2) Loosen the main gas connection and take
opposite direction using a 12 mm spanner. See					the appliance out of its seating.
Fig. N.					3) Apply the disassembly lever 483196 as
Then, using a 12 mm spanner, unscrew the					shown in Fig. W.
threaded component Fig. M2 from the component
Fig. M1, holding the latter firmly in the opposite
direction with a 12 mm spanner. See Fig. O.
L1
			M5
		M1	M2	M3	Fig W
			M2
L2	M5	M4
Z
L		Y		M	C) Reduced consumption adjustment of the
					cooktop burner taps.
					1 - Set the taps to the minimum setting.
					2 - Remove the control knobs from the taps. Fig. 6.
Fig N
22

Fig. M2 and replace it with the appropriate burner