HSN_4CupFoodProcManual08_2 8/22/08 1:31 PM Page 9
Assembling Your Attachments
Assembling Your Attachments
figure 5
figure 6
CORRECT PLACEMENT
figure 7
Note: All attachments must be firmly attached to the Spindle. Always adjust the attachments until you are sure that they are correctly fitted.
5Place the Chopping Blade over the Spindle until it snaps into place. See figure 5. The top of the Chopping Blade has a rim. Be sure to slide with rim side up onto Spindle. Refer to figure 6 for correct placement of the Chopping Blade onto the Spindle.
Note: If Chopping Blade is incorrectly placed onto Spindle (see figure 7), use a flat- tipped screwdriver or other blunt instrument to depress the flexible side tabs in order
to release the Blade from the Spindle. See figure 8.
6Place the assembled Spindle/Chopping Blade onto the Drive Shaft, see figure 9, next page. Ensure that the Spindle assembly is fully seated into the Drive Shaft. You should not see any of the metal stem on the bottom of the Spindle if it is properly assembled. It may be necessary to turn the Spindle slightly left or right.
7Place ingredients into the Processing Bowl.
|
|
|
| continued |
| figure 9 | 8 | Fit the Processing Cover to the Processing | |
| ||||
|
| Bowl (see figure 10), and place the Food | ||
|
|
|
| |
|
|
|
| Pusher in the Feed Tube. |
|
|
| 9 | Plug the power cord into a 120V AC power |
|
|
| ||
|
|
| ||
|
|
|
| outlet. |
|
|
| 10 | Start processing using the CONTINUOUS |
|
|
|
| ON or PULSE button. |
|
|
| 11 | When processing is complete, remove the |
|
|
|
| Spindle and Blade from the Processing |
|
|
|
|
Bowl before removing the processed food.
figure 10
Warning! Make sure motor has stopped completely before removing cover. If machine does not stop within four (4) seconds from turning power off call
Always turn machine off from Power button, NEVER use the lid as a means of turning the machine on or off.
WRONG PLACEMENT
figure 8
9 | 10 |