Care and Maintenance...
Spray arms.
Lime and remnants of food in the washing water can block the nozzles in the spray arms and the arm mountings.
-Inspect the nozzles in the spray arms for blocked holes due to remnants of food.
-If necessary, pull the lower arm upwards and lift it off.
-Unscrew the upper spray arm. Clean both spay arms under running water.
-
Protection from freezing temperatures.
If the appliance is installed in a location where there is a risk of freezing temperatures (eg. in a holiday home), all water must be completely drained out of the interior.
Turn OFF the tap, disconnect the supply hose and allow to drain.
Disconnecting the Dishwasher...
When disconnecting the appliance it is important that tasks are carried out in the correct sequence:
-Switch off at the mains and remove the plug from the socket.
-Turn off the water supply.
-Disconnect drain and water input hoses.
-Remove screws in underside of work surface. Detach board, if fitted.
-Pull out the appliance, carefully, withdrawing hoses at the same time.
Transporting the Dishwasher...
Drain water from the dishwasher. Secure all loose parts. The dishwasher should only be transported in an upright position.
If not kept upright during transport, any water remaining inside, may seep into the control module and cause subsequent errors with programme functions.
The appliance must be drained in the following sequence:
-Turn on the tap.
-Set the mains switch 1 to ON.
-Select theEconomy 50˚ button. The programme duration in minutes is shown in the numerical display.
-Wait for approx. 4 minutes.
-Terminate the programme by pressing programme end buttons 10 simultaneously.
-The time display changes to 0.
-Wait a further minute and then switch the dishwasher OFF.
-Turn off the tap.
22